Figure 4-30. Oil Filter Assembly - TM-5-6115-585-12

Figure 4-29.1. Replacing Oil Cooler Hoses

Figure 4-31. Replacing Oil Pressure Gauge - TM-5-6115-585-12_152

TM-5-6115-585-12 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 KW 1 Phase 2 Wire 1 Phase-3 Wire 3 Phase-4 Wire 120 120/240 and 120/208 Volts Manual
Page Navigation
98

TM5-6115-585-12 NAVFAC P-8-623-12 TO-35C2-3-455-1 TM-05684C/05685B-12 Figure 4-30. Oil Filter Assembly d. Install. Install switch (11) in adapter (5) and b. Remove. Drain oil filter into suitable container tighten. Use wrench on square portion of switch base. by removing drain plug (1). Loosen through bolt (2) Connect leads at terminals 1 and 2. and remove body (3). Remove and discard filter (6) and gasket (4). 4-32. OIL FILTER. c. Replace. Clean filter mounting area in adapter (5) and On ASK equipped generators, remove oil access door. inside of body (3). Install new element (6) in body (3). Install new gasket (4) in groove of adapter (5). Position body (3) (drain a. Service (see figure 4-30). Every 100 operating hours down) with element installed on adapter (5) and secure with replace oil filter element. Clean inside of bowl while filter is through bolt (2). Tighten through bolt 10 to 15 ft-lb dry. removed. Replace defective hoses. Change 8 4.36.1 /(4.36.2 blank)

Privacy Statement
Press Release
Contact