FUEL FILTER ASSEMBLIES AND STRAINER ASSEMBLY

Section IX. MAINTENANCE OF FUEL SYSTEM - TM-5-6115-585-12_123

TM-5-6115-585-12 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 KW 1 Phase 2 Wire 1 Phase-3 Wire 3 Phase-4 Wire 120 120/240 and 120/208 Volts Manual
Page Navigation
73

TM5-6115-585-12 NAVFAC P-8-262-12 TO-35C2-3-455-1 TM-05684C-12 Figure 4-7. Fuel Tank Assembly (4) Fuel Level Gauge. Engage threads of fuel (3) Check that drain valve is closed before filling level gauge (5) 1/2 turn into tank (9). Coat threads with sealing compound MIL-S-22473. Tighten float level gauge into tank using tools only on hex portion of gauge. Install filler cap (4) and strainer (5) into tank (9). g. Installation. (1) Install straps (3) onto the skid-base and se- cure with nut (1) and flatwasher (2) on inside of skid- base only. (2) Position fuel tank assembly onto skid-base, position straps over tank assembly and secure with nut (1) and flat- washer (2). On ASK equipped generators, install side closure, left panel and top panel assemblies (para. 5-4 and 5-5). tank with proper grade of fuel. NOTE After each time fuel filters or strainer is drained or elements replaced, purge air from fuel system by moving master switch on con- trol panel to PRIME & RUN position. This should activate the fuel transfer pump and force trapped air back to the vented fuel tank. 4-20. FUEL FILTER ASSEMBLIES AND STRAINER ASSEMBLY. There are two identical fuel filter assemblies (see figure 3-13), one which acts as the primary and the 4-17 Change 8

Privacy Statement
Press Release
Contact