TM 5-6115-465-34
N A V F A C P-8-625-34
T O 35C2-3-446-2
TM 06868B/06895D-34
(22) Remove lifting sling from side panel.
NOTE
Ensure lifting clevises are in the raised
(23) Repeat steps (20) thru (22) to install
p o s i t i o n before installing roof panel
other side panel.
assembly.
CAUTION
(28) Attach lifting sling to roof panel
Do not allow front lower panel to drop or
assembly, and position on gencrator set.
Ensure
set on ground. Damage to brackets could
alignment pins are in holes. It may be necessary to usc
result.
C-clamps to pull the side panels into position using the
lifting clevis as an anchor for the C-clamp. Remove
plastic plugs from rotolock holes. Align male and
(24) Position front lower panel assembly on
female rotolocks and, using hex tool, turn rotolocks to
generator set. Ensure top rubber flap is in raised
secure the roof panel assembly. Remove the lifting
position on radiator shell lip. Remove plastic plugs
from rotolock holes. Align male and female rotolocks
Install two sockethead capscrews to secure roof panel
and, using hex tool, turn rotolocks to secure the front
assembly.
plastic plugs. Ensure mounting zee is below bottom
(29) Raise sealing angle until it contacts roof,
.
tray assembly.
and tighten mounting hardware.
(25) Attach lifting strap, and raise front top
(30) Tighten capscrews securing mounting
panel assembly into position on side panels. Ensure
members.
alignment pins fit in holes for proper alignment.
Remove plastic plugs from rotolock holes. Align male
( 3 1 ) Attach lifting sling to inlet turn
assembly, and position on roof assembly. Remove the
and female rotolocks and, using hex tool, turn rotolock
lifting sling. Remove plastic plugs from rotolock
to secure the front top panel assembly. Remove lifting
holes. Align male and female rotolocks to secure the
plastic plugs.
(26) Position exhaust extension on engine
exhaust.
Install and tighten clamp to secure the
(32) Attach lifting sling to discharge turn
exhaust extcnsion. Exhaust extension opening must be
assembly, and position on roof assembly. Remove
p o i n t e d down and must not interfere with other
plastic plugs from rotolock holes. Remove lifting
components later.
sling. Align male and female rotolocks and, using hex
tool, turn rotolocks to secure the discharge turn
CAUTION
Do not allow rear panel assembly to drop
or set on ground. Damage to brackets
(33) Position upper side panel skirt on side
could result
p a n e l and install screws, washers, keepers, and
capscrews.
(27) Attach lifting strap and position rear
NOTE
panel asscmbly on gcncrator set. Ensure alignment
pins are in holes for proper alignmcnt. Remove plastic
Capscrews, keepers, and washers must be
plugs from rotolock holes. Align male and female
moved to end panels to secure side panel
rotolocks and, using hcx tool, turn rotolocks to secure
skirts.
thc rear panel asscmbly. Remove lifting strap. (Refer
(34) Install side panel skirts on slip-joint
to figure 826. ) Install plastic plugs. Ensure mounting
hinges a n d s e c u r e w i t h k e e p e r s .
zee is bclow bottom tray asscmbly.
8-42
Change 9