TM 5-6115-465-34
TO 35C2-3-466-2
NAVFAC P-8-625-34
T M 06858B/06859D-34
(1) Refer to operator and organizational
( 3 ) Locate left rear tiedown on skid base.
maintenance manual, para 3-134, and remove the
R e m o v e the ground stud. Measure down 5-1/8
following component from the generator set:
i n c h e s from lip of skid base, and 3-5/8 inches
battery box doors, radiator grille, side doors,
from vertical lip of skid base, Center punch where
l o u v e r doors under control panel, control panel
two lines meet. Refer to figure 8-24. Using ground
doors, and both front and rear top covers.
stud as a guide, drill two holes in skid base. (Refer
to figure 8-23.) Install ground stud in holes. Install
ground plate under ground stud. It may be
NOTE
n e c e s s a r y to remove wire ties from the ground
Remove all data plates and schematics
wire to the ground stud.
from generator panels. Mount generator
s e t data plate on lower right side of
NOTE
control panel using data plate as a
To remove the acoustic suppression kit
pattern for the rivet holes. Mount
schematics and data plates on rings
from shipping container, refer to steps
s u p p l i e d with acoustic suppression kit,
(25) through (14) and Step (8) of para
and place behind document box mounted
b(1) in reverse order. Ensure all com-
ponent are removed from shipping
on rear panel. Data plates and schema-
tics should be on separate rings. Rein-
container.
stall radiator mounting bolts after
r e m o v i n g radiator grille. One capscrew
in top left rear door hinge cannot
act.
be removed. Install hex nut on this
capscrew to prevent rattles.
CAUTION
NOTE
Location of first hole is critical. Read
steps (1) thru (4) and study figure
Some original hardware will be used
8-24 carefully before marking and
t o mount the acoustic suppression kit.
drilling first hole.
S t o r e all components removed and not
( 1 ) Using template supplied with acoustic
s u p p r e s s i o n kit installation components
suppression kit in vertical position, mark rear of
skid base in two positions. (Refer to figure 8-24.)
in accordance with local SOP. If acoustic
suppression kit is to be removed, original
generator components must be rein-
( 2 ) Using template in horizontal position,
m a r k rear of skid base in two positions. (Refer
stalled.
(2) Refer to operator and organizational
( 3 ) After making four marks, draw a vertical
maintenance manual, para 3-102, and remove the
and horizontal line through the marks. (Refer to
rain cap from the exhaust flange.
WARNING
(4) Where lines cross, drill a 1/2-inch hole.
(Refer to figure 8-24.)
D i s c o n n e c t batteries prior to removing
the ground stud. Death or serious injury
NOTE
could result.
WARNING
D o not tighten capscrews in step 5.
(5) Position mounting member on skid
Fuel tank is behind skid. Do not allow
base, and install the capscrew, flatwashers, lock-
drill bit to enter fuel tank. Death,
washer; and nut.
fire, or serious injury could result.
Change 9
8-40
