T O 35C2-3-442-2
P-8-627-34
TM-07464A-35
TM 5-6115-457-34
1.
Bolt (2)
16.
Lock
Key
31.
2.
Lock
17.
Bolt
Spacer
32.
3.
Bell assembly
18.
Lock
33.
Shaft assembly
4.
Gasket
19.
Bolt (2)
34.
Shaft assembly
Bolt (2)
5.
20.
Lock
35.
Gear assembly
Lock
6.
21.
Body assembly
36.
Bearing
Elbow
7.
22.
Bearing (2)
37.
Gear
8.
Gasket
38.
23.
Dowel (2)
Body assembly
9.
Pump assembly
24.
Body
39.
Shaft assembly
10.
Bolt (2)
25.
Cotter pin
40.
Dowel
11.
Lock (2)
41.
Shaft
26.
Nut
12.
Cover
27.
Washer
42.
Ball
13.
Spring
43.
28.
Gear
Dowel
14.
Plunger
29.
Key
44.
Bearing (2)
15.
Bolt (2)
Gear (2)
45.
30.
Body
e. Make sure that all shafts turn freely
c. Repair minor thread damage using a
suitable thread chaser.
with no binding or drag on gears after
r e a s s e m b l y . If gears bind, loosen bolts
(15, 17, and 19) slightly, and relocate the
8-178. REASSEMBLY.
pump bodies by tapping them lightly until
shafts turn freely. Retighten bolts (15,
17, and 19).
ble oil pump group in the reverse order of
index numbers assigned. Pay particular
8-179. INSTALLATION.
attention to the following:
a. Using a suitable arbor press, install
oil pump group.
bearing (36) flush with face opposite timing
mark.
gasket (15) and oil pan (20). Install wash-
b. Using a suitable arbor press, install
and 13), and bolts (6, 9, and 12).
beneath face of body (45) toward gear (28).
c. Connect water lines at the rear of
oil pan.
d. Connect oil pan drain line.
body (24) toward gears (30).
e. Install fuel fired heater and mount-
d. Using a suitable puller, install gear
ing brackets if so equipped.
(28) on shaft assembly (33). Tighten gear
retaining nut (26) to 60 foot-pounds torque,
f. Refer to engine run-in (para-
plus amount to align cotter pin (25).
graph 8-237) for testing of oil pump.
8-109
Change 8