P-8-627-34
T O 35C2-3-442-2
TM-07464A-35
TM 5-6115-457-34
Legend to figure 7-2:
8.
Insulation sleeving 0.625 ID
1.
Stator core
2.
Magnet wire 0.064 DIA (#14)
9.
Untreated glass tape 0.010 x 0.75
10.
Phase insulation
3.
Slot cell insulation (72)
11.
Insulation sleeving 0.330 ID
4.
Center spacer 0.032 thick
12.
Varnish
5.
Wedge (72)
13.
Insulation slot cell (72)
6.
Lead (6)
7.
Lead (6)
NOTE
Table 7-1. Generator Output Lead Lengths
sembly simplified schematic
diagram.
a. Heat main stator frame (86) in a
suitable oven to 200F for ease of in-
stalling main stator assembly (80).
b. Place heated main stator frame
assembly (86) in a vertical position, rest-
ing exciter end on wooden blocks.
CAUTION
Exercise care when installing main
stator assembly (80) into main
stator frame (86) to prevent damage
to windings.
c. Position main stator assembly (80)
so that pin (79) holes are aligned with holes
in main stator frame (86). Start leads (77)
through insulation bushing (85). Pull leads
and slide main stator assembly (80) into
main stator frame (86) until pin (79) holes
are aligned.
f. Position clamp (75) on generator
and install generator output leads
d. Install pin (79) and setscrew (78)
in the following sequence starting at
tighten to 5 foot-pound torque.
exciter end: T12, T11, TI0, T9, T8, and
T7. Install clamp (74) and install following
e. Cut output leads (77) to lengths
output leads starting at exciter end: T6,
specified in table 7-1. Strip insulation
T5, T4, T3, T2, and T1. Install clamp
back 0.62 inches and install terminal lugs
(73) and tighten nuts (70) finger tight.
on leads (77).
Change 8
7-11
