T O 35C2-3-442-2
P-8-627-34
TM-07464A-35
TM 5-6115-457-34
Refer to figure 6-36 and reassemble
6-148.
LOAD BOARD ASSEMBLY.
and install load board assembly as follows:
REMOVAL AND DISASSEMBLY.
6-149.
Refer to figure 6-36 and remove and dis-
Position load terminals (34) and bus
a.
assemble load board assembly as follows:
bar (39) on terminal board (40) and secure
with nuts (32).
a.
Remove protective cover (3) by
loosening studs (l).
Position load board assembly (31)
b.
b.
Disconnect lead (38) from bus bar
on bracket and secure with screws (28),
(39). Tag and disconnect contactor cables
lock washers (29), and washers (30).
(27) from load terminals (34) by removing
nuts (32) and washers (33).
Connect lead (38) to bus bar (39)
c.
and secure with screw (35), nuts (36), and
c.
Disconnect load board assembly
washers (37). Connect contactor cables
(21) by removing screws (28), lock washers
(27) to load terminals (34) and secure with
(28), and washer (30).
nuts (32) and washers (33).
d.
Remove load terminals (34) and
bus bar (39) from terminal board (40) by
Install protective cover (3) and
d.
removing nuts (32).
secure by tightening studs (1).
WARNING
TRANSFORMER ASSEMBLY.
6-153.
Cleaning Solvents are flammable and
moderately toxic to skin, eyes and
respiratory tract. Eye and skin
protect ion required. Good general
REMOVAL. Refer to figure 6-38
6-154.
ventilation is normally adequate.
and remove transformer assembly as
follows:
NOTE
Remove shield cover (4) by
a.
Note position of terminals
removing screws (l), lock washers (2)
prior to removal to insure
and washers (3).
proper installation.
Tag and disconnect electrical
b.
6-150.
CLEANING. Clean parts in an
wiring from transformers and terminal
approved cleaning solvent and dry
board.
thoroughly.
Cut tiedown straps connecting
c.
INSPECTION .
6-151.
generator leads together. Tag and dis-
connect six generator leads that pass
a.
Inspect threads for damage.
through transformer from reconnection board
studs. Remove leads from transformer.
b.
Inspect terminal board for cracks,
warping, and burnt areas.
Disconnect transformer assembly
d.
REASSEMBLY AND INSTALLA-
6-152.
(9) from generator by removing spacers (2),
TION.
screws (7), and lock washers (6 and 8).
6-121
Change 8
