P-9-TM-457-35 T.O. 35C2-3-442-2
TM-07464A-35 TM 5-6115-457-34
Legend to figure 6-17:
24.
Terminal board
1. Screw assembly (8)
25.
Screw
2. Cover (2)
26.
Standoff
3. Screw assembly (4)
27.
Shoulder washer (4)
4. Voltage regulator assembly
Insulated plate (2)
28.
5. Screw assembly (4)
29.
Nut
6. Transformer
Rectifier diode (2)
7. Screw assembly (4)
30.
31.
Nut
8. Control transformer
32.
Rectifier diode (3)
9. Screw assembly (4)
33.
10. Nut assembly (4)
Heatshield diode
11. Reactor
34.
Heatshield diode
12. Screw assembly (2)
Screw assembly (4)
35.
36.
13. Terminal board
Nut assembly (4)
37.
14. Screw assembly (4)
Screw (4)
15. Nut assembly (4)
38.
Nut (4)
Lock washer (4)
16. Screw assembly (4)
39.
17. Nut assembly (4)
Resistor (2)
40.
18. Wiring harness
Resistor
41.
19. Screw assembly
Resistor
42.
Mica washer (8)
20. Bridge rectifier assembly
43.
Washer (8)
21. Screw (2)
44.
Bracket (2)
22. Nut assembly (2)
45.
23. Washer (2)
Chassis
46.
6-83. INSTALLATION.
1. Between 395 and 480 volts for the
240/416 volt connection and between 197
Refer to figure 6-15 and install the
and 240 volts for the 120/208 volt connec-
tion; (60 Hz Mode I set).
exciter regulator. Secure the assembly in
position with four screws and nuts, then
connect plugs P9 and P13.
2. Between 380 and 426 volts for the
240/416 volt connection and between 190
6-84. ADJUSTMENT.
and 213 volts for the 120/208 volt connec-
tion; (50 Hz Mode I set).
a. Set voltage range resistor R33 in a
position so that generator output voltage
can be adjusted at any loads between no load
3. Between 395 and 458 volts for the
and rated load. Adjust VOLTAGE ADJUST-
240/416 volt connection and between 197
MENT resistor R2 (on control cubicle) to
and 229 volts for the 120/208 volt connec-
meet the following requirements.
tion; (400 Hz Mode II set).
6-51
Change 1
