• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 5-33. Application Kit Electrical Schematic Diagram
CAUTION

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
  445    446    447    448    449  450  451    452    453    454    455  
ARMY TM 9-6115-464-34 AIR FORCE TO 35C2-3-445-2 NAVY  NAVFAC  P-8-624-34 Section   VI.   ACOUSTIC   SUPPRESSION   KIT 5-28.  GENERAL The acoustic suppression kit provides the ability to lower the noise level of the generator set to 70 dB(A) at 7 meters. It consists of panels, doors, and components that rover or replace original components of the generator set. The generator set is operated and maintained in the same manner; however, access to components and operation will change slightly due to configuration changes. Remember that the overall weight and cube of the generator set will increase with the acoustic suppression kit installed. (Refer to TM 9-8115-464-12, para 1-10.) Inspect the components of the acoustic suppression kit upon delivery for bends, cracks, dents, missing components, or other damage. 5-29. ACOUSTIC SUPPRESSION KIT INSTALLATION AND REMOVAL. NOTE Do not allow components with rubber seals to slide on surfaces. Damage to rubber seals will result. a. Prepare generator set for installation of acoustic suppression kit. (1) WARNING Do not use hoisting equipment with maximum capacity less than 5,000 pounds. Do not allow generator set to swing while suspended. Do not allow personnel under generator set or components of acoustic suppression kit when hoisted or lifted. Death or severe injury may result. CAUTION Use a minimum bridle of 5 feet on the hoisting sling to avoid undue side pressure on the lifting frame. Failure to observe this caution could result equipment damage. NOTE If generator set is trailer–mounted, generator set must be removed from trailer, and rubber isolators supplied with kit placed between the generator set and trailer mounting surface. When installing the generator set, attach anti-rotation clip, and attach the mounting bolts. Bolts should be torqued to 5 ft- lb (6.80 Nm) and jam nuts installed. (Jam nuts are common hardware items.) Once the acoustic suppression kit is installed, gen set will require 1 inch ground clearance. Do not skid gen set with acoustic suppression kit installed. Do not forklift unless both side panel skirts are in the raised position. If generator set is trailer-mounted, the trailer brackets supplied with kit must be installed. The brackets allow for the extended length when the acoustic suppression kit is installed. Refer to operator and unit maintenance manual, paragraph 4-135, and remove the following: battery box doors, radiator grill, side doors, louver doors under control panel, control panel doors, and both front and rear top covers. 5-70







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.