• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Cleaning.  Inspection.  and Repair
Section   XVI.   MAINTENANCE   OF   LIFTING   FRAME

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
  343    344    345    346    347  348  349    350    351    352    353  
ARMY   TM   9-6115-464-34 AIR  FORCE  TO  35C2-3-445-2 NAVY  NAVFAC  P-8-624-34 c. Cleaning, Inspection, and Repair. WARNING Solvent, Dry Cleaning P-D-680, Type II is flammable and moderately toxic to skin, eyes and respiratory tract. Eye and skin protection required. Good general ventilation is normally adequate. Failure to observe this warning could result in servere personal injury or death. (1)  Clean relay table parts in dry cleaning solvent (Federal specification P-D-680) and dry thoroughly. (2)  Inspect relay table for breaks, cracks, and other damage. (3)  Check ail parts for defective paint. (4)  Check all threads for crossing, stripping, and peening. (5)  Repair cracks, breaks, and defective welds by welding. (6)  Replace any parts damaged beyond repair. (7)  Remove defective paint and corrosion. Treat and paint in accordance with service requirements. d. Installation. (1) (2) (3) (4) (5) (6) (7) (8) (9) Position left side relay table (31, figure 3–149), to install screw (30), flatwasher (29), Iockwasher (28) and nut (27). Position rear housing (24), to install screw (23), flatwasher (22), Iockwasher (21) and nut (20). Position right side relay table (26), to install screw (19),flatwasher(18), Iockwasher (17) and nut (16). Install fuel line (15). Position spacer (14), to install flatwasher (13), Iockwasher (12), and screw (11). Position top relay table (25), to install flatwasher (10), Iockwasher (9), and screw (8). Install terminal block (7), and screws (6 and 5). Install nut (4), clamp (3), Iockwasher (2) and screw (1). Refer to the Operator and Unit Maintenance Manual and install housing assembly doors, covers, and panels. e. Installation for KZ00001 and up serial numbers (1) (2) (3) (4) (5) (6) Position top relay table (21, figure 3-1 50) to install screws (32), flatwashers (31), Iockwashers (30) and nut (29). Install grommet (28). Position Ieft side relay table (27), screw (26), flatwasher (25), Iockwasher (24) and nut (23). Install rear housing (20), screw (19), flatwasher (18), lockwasher (17) and bolt (16). Position right side relay table (22), to install screws (15), flatwasher (14), Iockwasher (13) and nut (12). Install fuel line (11). 3-313







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.