• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 3-34. Hydraulic Pump Assembly, Exploded View
Figure 3-35. Hydraulic System Filter Assembly, Exploded View

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
  118    119    120    121    122  123  124    125    126    127    128  
ARMY TM 9-6115-464-34 AIR FORCE TO 35C2-3-445-2 NAVY  NAVFAC  P-8-624-34 3-42. HYDRAULIC SYSTEM FILTER ASSEMBLY. a.  Removal. (1) Disconnect hydraulic lines (1, figure 3-35), and drain hydraulic fluid into a suitable container. (2) Remove nuts (2), Iockwashers (3) and screws (4) to remove filter assembly. (3) Do not remove screws (5), Iockwashers (6), nuts (7) and mounting bracket (8) unless inspection reveals  damage. b. Disassembly. (1) Remove Iockwire (9) and unscrew housing (10). (2) Remove and discard filter element (11), backup ring (12), packing (13) and backup ring (14). (3) Remove elbows (15), o-rings (16), washers (17) and nuts (18) from head assembly (19). Discard o - r i n g s. (4)  Do  not  remove  pressure  relief  valve  (20). c. Cleaning,  Inspection,  and  Repair. (1) (2) (3) (4) (5) (6) Clean all parts in dry cleaning solvent (Federal Specification P-D-680) and dry thoroughly with filtered compressed air. Visually inspect mounting bracket for cracks, breaks and corrosion. Inspect housing for cracks, corrosion, and other damage. Inspect head assembly for cracks, breaks, and corrosion. Check parts for deposits of foreign material. Remove any deposits found. Check all threads for crossing, stripping, and peening. Repair minor thread damage with a thread chaser. Replace any damaged or defective parts. d.  Assembly. NOTE Soak replacement filter element in oil conforming to Military Specification MIL-H-5606 to remove trapped air before installing. (1)  If  removed,  install  pressure  relief  valve  (20). (2) Position head assembly (19), to install nuts (18), washers (17), new o-rings (16), and elbows (15). (3) Install backup ring (14), packing (13), backup ring (12) and new filter element (11). (4)  Install  housing  (10)  and  Iock  wire  (9). e. Installation. (1) If removed, install mounting bracket (8, figure 3-35), nuts (7), Iockwashers (6) and screws (5). (2) Position filter assembly to install screws (4), Iockwashers (3), and nuts (2). (3)  Connect  hydraulic  lines  (1),  and  fill  with  hydraulic  fluid. 3-87







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.