Section II. OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SER- VICES (PMCS)

Figure 2-4 Base Frame Assembly, J3 SLAVE RECEPTACLE 24 VOLTS

TM-9-6115-668-13 5Kw 28VDC Auxiliary Power Unit (APU) MEP 952B Manual
Page Navigation
37

TM 9-6115-668-13 Section II. OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SER- VICES (PMCS) 2.2 INTRODUCTION TO OPERATOR PMCS TABLE. Table 2-4 (PMCS table) has been provided so you can keep your equipment in good operating condition and ready for its primary mission. 2.2.1 Warnings. Cautions, and Notes. Always observe the WARNINGS, CAUTIONS, and NOTES appearing in your PMCS table. Warnings and cautions appear before applicable procedures. You must observe WARNINGS to prevent serious injury to yourself and others. You must observe CAUTIONS to prevent your equipment from being damaged. You must observe NOTES to ensure procedures are per- formed properly. 2.2.2 Explanation of Table Entries. The PMCS table is divided into five columns. Each column is ex- plained in the following paragraphs. 2.2.2.1 Item No. Column. Numbers in this column are for reference. When completing DA Form 2404 (Equipment Inspection and Maintenance Worksheet), include the item number for the check/service indi- cating a fault. Item numbers also appear in the order that you must do checks and services for the inter- vals listed. 2.2.2.2 Interval Column. This column tells you when you must do the procedure in the procedure col- umn “BEFORE” procedures must be done before you operate the equipment for its intended mission. “DURING” procedures must be done during the time you are operating the equipment for its intended mission. “AFTER” procedures must be done immediately after you have operated the equipment. Per- form ‘WEEKLY” procedures at the listed interval. 2.2.2.3 Location. Item to Check/Service Column. This column lists the location and the item to be checked or serviced. The item location is underlined. 2.2.2.4 Procedure Column. This column gives the procedure for checking or servicing the item listed in the location, item to check/service column. You must perform the procedure to know if the generator set 150 kW is ready or available for its intended mission or operation. You must do the procedure at the time stated in the interval column. 2.2.2.5 Not Fully Mission Capable If: Column. Information in this column tells you what faults will keep your equipment from being capable of performing its primary mission. If you make checks or ser- vices that shows faults listed in this column, do not operate the equipment. 2.2.3 Other Table Entries. Be sure to observe all special information and notes that appear in your table. 2 - 1 2

Privacy Statement
Press Release
Contact