TM 9-6115-660-13&Pd. Remove slide hammer components from accessory box and assemble as follows:(1)(2)(3)(4)(5)If installed, remove nut (6, figure 2-6) from rod (4).Place hammer (5) on rod (4).Install nut (6) on rod (4) and tighten to end of threads.WARNINGImpact disk must be tightened to end of threads on rod. Also, lock washerand nut must be firmly tightened against impact disk. Failure to observethis warning could result in severe personal injury or death and damage tothe equipment.Check that impact disk (3) is tightened to end of threads on rod (4). Tighten as needed.Tighten nut (1) and lock washer (2) securely against impact disk (3).e. Remove ground rod as follows:CAUTIONSlide hammer rod and ground rod must make firm contact inside groundrod coupler. If not in firm contact, ground rod, coupler and slide hammercould be damaged.(1)(2)(3)(4)(5)(6)(7)(8)(9)Refer to figure 2-15 and position slide hammer above ground rod coupling (3). Invert slidehammer so that end having impact disk (1) is up. Connect slide hammer rod (2) to groundrod coupling (3). Tighten so that end of rod (2) makes firm contact with end of ground rodsection (4) inside coupling (3).Use slide hammer to pull ground rod section (4) out of ground. Pull until second coupling(3) is exposed.Disconnect slide hammer from top coupling (3).Disconnect top ground rod section (4) from bottom coupling (3).Remove clamp (5) from ground rod (4). Store clamp in accessory box.Connect sIide hammer rod (2) to coupling (3) on ground rod section (4) still in ground.Use slide hammer to pull second ground rod section (4) out of ground. Pull ground rodsection (4) until third coupling (3) is exposed.Repeat steps (3) through (5) for third ground rod section (4).Use slide hammer to pull remaining ground rod section (4) out of ground.2-42
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
