4-5 INSTALLATION INSTRUCTIONS

Section Il. SERVICE UPON RECEIPT - TM-9-6115-659-13P_100

4-5.2.2 Assembly of Power Plant AN/MJQ-35A

TM-9-6115-659-13P Power Unit PU-732/M (NSN 6115-00-280-3082) MEP-118A 15 Kw 400 Hz Generator Set M200A1 2-Wheel 4-Tire Modified Trailer Manual
Page Navigation
74

TM 9-6115-659-13&P 4-4.3 Deprocessing Unpacked Equipment Refer to DA Form 2258, Depreservation Guide for Vehicles and Equipment, packed with the power plant/power unit. The depreservation guide explains what was done to the equipment prior to packaging. It also explains what has to be done before placing the equipment in operation. Perform all depreservation actions required by the depreservation guide. 4-5 INSTALLATION INSTRUCTIONS. 4-5.1 Tools, Test Equipment, and Materials Required for Installation. A general mechanic’s tool kit is required for installation of the power plant/power unit. 4-5.2 Assembly of Equipment. 4-5.2.1 Assembly of Power Plants AN/MJQ-35 and AN/MJQ-36. Refer to figure 4-1 and assemble the AN/MJQ-35 and AN/MJQ-36 Power Plants as follows: NOTE Refer to sheet 1 of figure 4-1 for installation of power cables on AN/MJQ-35 and sheet 2 of figure 4-1 for installation on AN/MJQ-36. a. For front generator set, remove stuffing tube locknut (1) from stuffing tube body (7). Slide locknut (1) off power cable leads and ground cable (3). b. Loosen compression nut (4). Pull in required length of cable to allow installation of leads on terminal board. c. Insert power cable leads (ends without terminal lugs) (3) through generator output plate (2). Slide stuffing tube locknut (1) over power cable leads. d. Position stuffing tube body (7) against generator output plate (2). Install and tighten stuffing tube locknut (1). e. Connect power cable leads and ground cable as follows: (1) Connect lead marked L1 to generator set load terminal L1. (2) Connect lead marked L2 to generator set load terminal L2. (3) Connect lead marked L3 to generator set load terminal L3. (4) Connect lead marked LO to generator set load terminal LO. (5) Connect lead marked GND to generator set GND terminal. f. Position cable inside two clamps (10) and secure clamps (10) to trailer using two screws (8), flat washers (9), and nuts (11). g. Repeat steps a. through f. for rear generator set. h. Remove wing nut (12), two flat washers (13), hex nut (14), and flat washer (15). Change 2 4-5

Privacy Statement
Press Release
Contact