TM 9-6115-604-34
NAVFAC P-8-633-34
Figure 9-81. Tightening Sequence, Intake Manifolds
9-44. EXHAUST MANIFOLDS MAINTENANCE.
a.
Remove.
(1)
Remove the aftercooler in accordance with paragraph 9-42.
NOTE
The manifold may be removed in sections if desired. Remove the center section after
removing either end section.
(2)
Straighten the tabs on the Iockplates (2, Figure 9-82), and remove the capscrews (1), lockplates (2), and
washers
(3)
Discard the lockplates.
(3)
Remove the manifold sections, (4, 5, and 6), and remove and discard the gaskets (7).
(4)
Disassemble the manifold by twisting and pulling the sections (4,5, and 6).If difficulty is encountered in
removing the sections, tap lightly around the slip-joints using a plastic or rawhide mallet.
Figure 9-80. Tightening Sequence, Air Balance Connections
9-141
