SECTION VlI. FUEL MANIFOLDS

Figure 6-34. Test Set (Typical), Synchronizer A105 (Sheet 1 of 2)

Figure 6-35. Fuel Manifolds and Related Parts, Exploded View

TM-9-6115-604-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 Kw. 1 Phase-2 Wire 1 Phase -3 Wire 3 Phase -4 Wire 120. 120/240 and 120/208 Volts Manual
Page Navigation
266

TM 9-6115-604-34 NAVFAC P8-633-34 TERMINALS NORMAL VOLTAGE FROM TO 9(+) 10(-) 24 V DC 1 2 NOMINAL 208 V RMS 3 4 NOMINAL 208 V RMS 5 10(-) 5 TO 20VDC 8 10(-) 5.0() 0.3VDC 11 10(-) ZERO VDC 15 16 1 VDC (MAX) 7 10 3.5 TO 3.6 6.5 VDC 6 10(-) 3.5 TO 3.6 6.5 VDC Figure 6-34. Test Setup (Typical), Synchronizer A105 (Sheet 2 of 2) SECTION VlI. FUEL MANIFOLDS 6-24. GENERAL. Fuel manifolds are used to distribute the fuel from the fuel pump to the injector passages in the cylinder heads. Procedures for replacement of the manifolds and related parts are contained in this section. 6-25. FUEL MANIFOLD REMOVAL . Procedures in this paragraph may on only be performed with the intake manifolds removed. Refer to paragraph 9-43 for both removal and installation of the intake manifolds. a. Right Bank Manifold. See Figure 6-35. (1) Disconnect fuel supply and fuel drain tubes (7 and 10) at the fuel block connection (13). Remove the fitting and ferrule assemblies (1). (2) Disconnect fuel supply and fuel drain tubes (7 and 10) at the fuel block connection (5). Remove the fitting and ferrule assemblies (1). (3) Remove socket head capscrews (6) to remove fuel block connection (5). Remove and discard preformed packings (4). (4) Remove fuel manifold assemblies (27) by removing socket head capscrew (25). Remove and discard preformed packings (26). b. Left Bank Manifold. See Figure 6-35. (1) Remove left bank fuel supply tubes (7 and 10) and fuel block connection (5) in accordance with step a(1), (2), and (3), above. (2) Remove fuel manifold assemblies (30) by removing socket head capscrews (25). Remove and discard preformed packings (26). 6-65

Privacy Statement
Press Release
Contact