Maintenance of Filler Cap and Strainer

TM-9-6115-604-12 Generator Set Diesel Engine Driven Tactical Skid Rtd. 60 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
147

ARMY TM 9-6115-604-12 NAVY NAVFAC P-8-633-12 CAUTION When ether system is not required, the ether start tank (1) should be removed and stored in a safe, designated area. Cap should be threaded into solenoid valve (2) to ensure cleanliness. (2) Service. (a) Remove ether start tank (1) from solenoid valve (2) and cylinder clamp (3) Shake the tank to determine existing supply of ether. (b) If supply is adequate, reinstall ether tank If tank is empty, Install new tank in solenoid valve (2) and tighten cylinder clamp (3). h. Maintenance of Filler Cap and Strainer. See Figure 3-16. (1) Inspect. (a) Remove fuel tank cap (4). (b) With a flashlight, Inspect Inside of element strainer (5). Strainer protection plate, located mid-way down the tube, should be free of debris and securely attached. (c) Check wire strainer located In base of element strainer (5) for accumulation of dirt or other foreign matter (d) Check that the fuel tank cap chain is securely attached to fuel tank cap (4) and element strainer (5) Fuel tank cap vent should be In OPEN position. (2) Service. (a) Replace fuel tank cap gasket if worn or fitting is loose. (b) Remove fuel tank cap (4), along with its attaching chain, from element strainer (5). (c) Slide element strainer (5) out of filler neck and housing (6). Dry cleaning solvent, P-D-680, Type II, Is flammable and moderately toxic to the skin, eyes, and respiratory tract. Skin, eyes, and respiratory tract protection Is required to avoid injury to personnel. (d) Cleaning solvent P-D-680, Type II, or equivalent, and a stiff bristle brush (nonmetallic) may be used In cleaning filler neck element strainer. (e) Inspect wire cone strainer for punctures, cuts, and tears If damaged, a new element strainer (5) is required. (f) Check strainer protector plate Inside element strainer (5). It should be firmly attached. (g) Slide element strainer (5) into filler neck and housing (6). (h) Reattach fuel tank cap (4), fastening the chain to the clip provided inside element strainer (5). (3) Replace Remove and replace defective parts in accordance with step (2), above. 3-42

Privacy Statement
Press Release
Contact