ARMY TM 9-6115-464-34AIR FORCE 35C2-3-445-2NAVY NAVFAC P-8-624-34(i) lf winterization kits are installed, tag and disconnect electrical Ieads to engine sensors and(2)(3)(4)(5)(6)(7)(8)(9)disconnect coolant lines from engine oil pan.CAUTIONDo not use a lifting device of less than 1000 lb. capacity. Failure to observe this cautioncould result in damage to the equipment.Attach a suitable lifting device to engine lifting brackets.Disconnect engine crankcase oil drain tube from fitting in skid base.Remove screw (1, figure 2-1), Iockwasher (2), and access cover (3).Remove screws (4), Iockwashers (5) and air inlet screen (6).Remove screws (7) and lockwashers (8), Iockplate (9) and pressure plate (10).CAUTIONTake slack from hoisting sling prior to loosening generator and engine coupling bolts.Failure to observe this caution could result in damage to the equipment .Remove screws (11) and Iockwasher (12).Remove bolts (13) and Iockwashers (14).CAUTIONMake a final, thorough check to ascertain that the engine is completely disconnectedfrom the generator set prior to attempting to hoist it clear. Failure to observe thiscaution could result in damage to the equipment.Carefully move the engine up and forward until generator coupling disc clears engine flywheelhousing.CAUTIONDo not use a lifting device of less than 1000 lb. capacity. Failure to observe thiscaution could result in damage to the equipment.b. Installation.(1) To install engine, use a suitable lifting device to lift engine by the hooks located on the engine.(2) Carefully lower the engine (15, figure 2-1) until generator coupling and engine flywheel housingalignment matches.(3) .Alignment pins with 5/8 inch headless bolt should be screwed into holes in the flywheel to facilitatealignment.(4) Tighten down engine bolts Iecated in front of the engine to secure alignment. Torque according toparagraph 1-10y(5) Install Iockwashers (14), and bolts (13).(6) Install Iockwashers (12), and screws (11).(7) Install pressure plate (10), Iockplate (9), Iockwashers (8), and screws (7).(8) Install air inlet screen (6), Iockwashers (5), and screws (4).2-16
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
