ARMY   TM   9-6115-464-34 AIR  FORCE TO 35C2-3-445-2 NAVY  NAVFAC P-8-624-34 1. Screw 2.   Lockwasher 3.   Screw & captive washer assy 4.   Cover 5.   Locking   nut 6.    Nut 7.  Tooth  Iockwasher 8. Potentiometer 9.    Nut 10. Screw  & captive washer assy 11. Nut 12. Screw  & captive washer assy 13. Wiring harness assy 14. Nut 15. Screw  & captive washer assy 16. Shorting plug 17. Nut 18. Screw & captive washer assy 19. Protective cap assy 20. Nut & captive washer assy 21.  Flat  washer 22. Screw 23. Nut and captive washer assy 24. DC relay assy 25. Nut & captive washer assy 26. 27. 28. 29. 30. 31. 32. 33. 34. 35. 36. 37. 38. 39. 40. 41. 42. 43. 44. 45. 46. 47. 48. 49. 50. Screw Instrument  shunt Nut  captive  washer  assy Screw Special current transformer Nut Lockwasher Screw Cranking  relay Nut & captive washer assy Screw Terminal board assy Nut Screw  &  captive  washer  assy Resistor Resistor  bracket  assy Nut  & captive washer assy Screw Terminal  board  assy Terminal  jumper Chassis Resistor Bracket  assy nut Screw  &  captive  washer  assy Figure 3-119. Special Relay Assembly, Exploded View (Sheet 2 of 2) (18) If any dc relay assembly component must be replaced or encapsulating coating repaired or replaced, refer to Appendix A references for detailed procedures. Repair/replace encapsulating by applying a 0.007 inch (min) coating of polyurethane resin (Scotchcast 221, Minnesota Mining and Mfg. Co. or equal). (19) Replace any damaged or defective parts. d.  Assembly. (1) Install screw and captive washer assembly (50, figure 3-119), nut (49), bracket assembly (48) and resistor  (47). (2) Install terminal jumper (45), terminal board assembly (44), screw (43) and nut & captive washer assembly  (42). (3) Install resistor bracket assembly (41), resistor (40), screw & captive washer assembly (39), and nut (38). (4) Install terminal board assembly (37), screw (36), nut & captive washer assembly (35). (5) Install cranking relaly (34), screw (33), Iockwasher (32), and nut (31). (6) Install special current transformer (30), screw (29), nut & captive washer assembly (28). (7) Install instrument shunt (27), screw (26), nut & captive washer assembly (25). (8) Install dc relaly assembly (24), and nut & captive washer assembly (23). (9) Install screw (22), flat washer (21), and nut &captive washer assembly (20). (10) Install protective cap assembly (19), screw & captive washer assembly (18) and nut (17). (11) Install shorting plug (16), screw&captive washer assembly (15), and nut (14). (12) Install wiring harness assembly (13), screw &captive washer assembly (12), and nut (11). 3-251