ARMY TM 9-6115-464-34
AIR FORCE TO 35C2-3-445-2
NAVY NAVFAC P-8-624-34
NOTES:
INSTALL CABLE STRAPS, FIND NO. 7, AT 1.5 INTER-
VALS AND AT EACH CABLE BREAKOUT.
1.
2.
3.
4.
5.
6.
7.
8.
CRIMP STYLE TERMINALS, FIND NO. 5, SHALL BE
IN ACCORDANCE WITH MIL-STD-454, REQUIRE-
MENT 19.
CONDUCTOR ENDS WITHOUT TERMINALS OR CON-
NECTORS SHALL BE STRIPPED .25 INCH AND TINN–
ED IN ACCORDANCE WITH MIL-STD-454, REQUIRE-
MENT NO. 5.
SODER ALL CONNECTORS IN ACCORDANCE WITH
MIL-STD-454, REQUIREMENT NO. 5
EACH WIRE SHALL BE PERMANENTLY AND
LEGIBLY IDENTIFIED AT EACH END OF THE WIRE.
INSTALL INSULATION SLEEVING, FIND NO. 8 OVER
EACH SOLDER CONNECTION TO CONNECTORS
(FIND NO. 1,2,3 AND 4) AND HEAT SHRINK TO A
FIRM FIT. SLEEVING SHALL EXTEND OVER WIRE
INSULATION AT A MINIMUM OF .25 IN.
REFERENCES:
FOR ELECTRICAL WIRING DIAGRAM, SEE
DRAWING 69-730
FOR ELECTRICAL SCHEMATIC DIAGRAM, SEE
DRAWING 69-729
FOR INTERPRETATION OF:
REFERENCE DESIGNATIONS FOR ELEC-
TRICAL AND ELECTRONICS AND
EQUIPMENTS, SEE ANS Y32.16
DIMENSIONING AND TOLERANC–
ING, SEE ANS Y14.5
Figure 3-69. 50/60 Hz Governor Control Unit Wiring Harness, Drawing No. 69–731 (Sheet 2 of 2)
3-167
