ARMY TM 9-6115-464-12AIR FORCE TO 35C2-3-445-1NAVY NAVFAC P-8-624-12NOTEThe terms ready/available and mission capable refer to the same status: equip-ment is on hand and is able to perform its combat mission.NOTELeakage definitions for operator PMCS shall be classified as follows:Class I: See page of fluid (as indicated by wetness or discolorization) not greatenough to form drops.Class II: Leakage of fluid great enough to form drops but not enough to causedrops to drip from the item being checked/inspected.Class Ill: Leakage of fluid great enough to form drops that fall from the item beingchecked/inspected.Equipment operation is allowable with minor leakages (Class I or II). Ofcourse, you must consider the fluid capacity in the item/system beingchecked/inspected. When in doubt, notify your supervisor.When operating with Class I or Class II leaks, continue to check fluid levelsas required by PMCS.Equipment damage could result if caution is not observed.2-31REPORTING DEFICIENCIES. If your equipment does not perform as required, and if you discover prob-lems during PMCS that you are unable to correct, it must be reported. Refer to DA Pam 738-750 and report thedeficiency using the proper forms.NOTEFor generator sets in continuous operation, check and service only those items thatcan be checked and serviced without disturbing operation. Perform a completePMCS when equipment can be shutdown. Deficiencies discovered during opera-tion shall be noted for future correction. Stop the operation immediately if a deficien-cy is noted which could damage the equipment. Report all deficiencies and correc-tive actions on proper forms. Army, refer to DA Pamphlet 738-750. Air Force, referto applicable inspection manuals and work card sets in the TO 35C2-3-1-426 seriesfor periodic requirements and Table 2-2 for detailed procedures. Operator PMCSapply to Navy users in this manual.2-36
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
