ARMY TM 9-6115-464-12
AIR FORCE TO 35C2-3-445-1
NAVY NAVFAC P-8-624-12
(3) Testing.
(a) Place circuit breaker in OPEN position.
(b) Using an ohmmeter or similar device, check for open circuit between terminals using Figure 5-13
as a guide.
(c) Place circuit breaker in CLOSED position and check for continuity between terminals.
(d) Replace circuit breaker if it fails to meet the above continuity requirements.
(4) Installation.
(a) Install circuit breaker (16, Figure 5-12), cover (15), and screws (14).
(b) Connect electrical leads to circuit breaker.
(c) Install control box cover as outlined in subparagraphs c. (4) (a) above.
e.
Indicator Light.
(1) Removal.
(a) Remove control box cover as outlined in subparagraph c. (1) (a) above.
(b) Tag and disconnect electrical leads to indicator light.
(c) Unscrew lens (17) and remove O-ring (18) and lamp (19).
(d) Remove nut (20) to remove base (21) and nut (22).
(2) Cleaning and Inspection.
(a) Clean indicator light with filtered compressed air and a soft bristle brush or wipe with a clean,
lint-free cloth lightly moistened with an approved solvent.
(b) Visually inspect light for cracks, corrosion, cracked or broken lens, stripped or damaged
threads, burns and other damage.
(c) Check lamp for burned out filament.
(d) Replace only parts found damaged.
(3) Installation.
(a) Install nut (22, Figure 5-12), base (21), and nut (20).
(b) Install lamp (19), O-ring (18), and screw lens (17).
(c) Connect electrical leads to indicator light.
(d) Install control box cover as outlined in subparagraph c. (4) (a) above.
f.
Terminal Board Assembly.
(1) Removal.
(a) Remove load bank assembly as outlined in paragraph 5-21 c. (1) above.
(b) Tag and disconnect electrical leads to terminal board assembly.
(c) Remove screws (23, Figure 5-12), plastic washers (24), nuts (25), flat washers (26) and washers
(27) to remove terminal board assembly (28).
(2) Cleaning and Inspection.
(a)
(b)
(c)
Clean terminal board with filtered compressed air and a soft bristle brush or wipe with a clean,
lint-free cloth lightly moistened with an approved solvent.
Visually inspect terminal board for cracks, corrosion, burns and stripped or damaged threads.
Replace terminal board if damaged beyond simple repair.
5-55
