Figure 3-2. Preheat System Contactor K107 and Heater Contactor K109, Exploded View

Figure 3-3. Transfer Contactor K108, Exploded View

TM-5-6115-593-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 600 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
35

TM5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 (2) Separate the coil (4) from the magnet assembly (3). (3) When replacing coil (4) the magnet must be installed with the word FRONT appearing as shown in figure 3-4. NOTE Recommended driving torques for items 1, 5, and 7 are 18 to 21 inch-pounds (2 to 2.4 joules), and item 6 is 6 to 9 inch-pounds (0.7 to 1 joules). (4) Remove and replace overload assembly (8) by removing screws (7). NOTE Contacts are not harmed by light discoloration and slight pitting. Do not file them. Replacement is necessary only when the contact has worn thin. (5) To replace movable contacts (6), place contactor (nameplate down) on a flat surface and insert a replacement movable contact finger. Figure 3-2. Preheat System Contactor K107 and Heater Contactor K109, Exploded View 3-4

Privacy Statement
Press Release
Contact