TM5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 Legend for Figure 11-1 (Sheet 1) 1. Screw 39. Buss bar 2. Washer 40. Jumper bar 3. Washer 41. Buss bar 4. S hook 42. Buss bar 5. Screw/washer 43. Jumper bar 6. Nut/washer 44. Buss bar 7. Chain 45. Buss bar 8. Snap hook 46. Screw 9. S hook 47. Washer 10. Chain 48. Nut 11. Sleeving 49. Buss bar 12. Front panel 50. Buss bar 13. Support 51. Screw 14. Screw 52. Washer 15. Washer 53. Washer 16. Washer 54. Nut 17. Nut 55. Block 18. Angle 56. Clamp 19. Screw 57. Clamp 20. Washer 58. Screw 21. Washer 59. Washer 22. Nut 60. Nut 23. Plate 61. Clamp 24. Screw 62. Screw/washer 25. Washer 63. Nut/washer 26. Washer 64. Clamp 27. Nut 65. Screw 28. Enclosure 66. Washer 29. Screw 67. Washer 30. Washer 68. Nut 31. Screw 69. Screw/washer 32. Screw 70. Nut 33. Washer 71. Harness 34. Screw 72. Grommet 35. Screw 73. Harness 36. Washer 74. Power cable 37. Nut 75. Lug 38. Buss bar 76. Cable 77. Screw b. Replacement. (1) Replace current transformer assembly (22, figure 11-1, sheet 2) by replacing the ten screws (20 and washers (21). (2) Replace reconnection boars and buss bars, par. 11-2 b. 11-4.  CURRENT TRANSFORMERS.  The current transformers are mounted on a plate in the reconnection box assembly enclosure, attached to the main generator. An on-equipment test is not feasible for current transformer assembly.  Refer to figure 11-1, sheet 2 and 11-2 to provide access to current transformer for removal. a. Inspection.  Inspect the current transformers (figure 11-2) for cracks in the plastic, breaks, loose mounting, loose connections, or corrosion. CAUTION Current transformers must be demagnetized after checking any secondary terminals with any DC current such as a Wheatstone bridge, or their accuracy will be impaired. 11-3