TM5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 c. Inspection. (1) Inspect for burnt or broken insulation. (2) Inspect  if  insulation  is  dry,  brittle  or  faded. Revarnish as necessary. (3) Check  bearings  for  visible  signs  of  damage, excessive wear, or discoloration.  Replace as necessary. d. Repair.      Repair   of   the   fan   motor   consists   of replacing broken, worn or defective components found during inspection and drying or revarnishing  of  windings  if  required  as  a  result of the megger test. e. Reassembly.      Reassemble   motor   as   follows (see figure 7-2). (1) Install stator winding (21) and core (20) inside stator frame (19). (2) Install shaft (18) and motor assembly (17). (3) Install drive end bearing (15). (4) Install  drive  end  bracket  (14)  and  secure  to stator frame with studs (8) and nuts (7). (5) Install collar shield (13). (6) Install rear bearing (11) and spring (10). (7) Install   opposite   drive   end   bracket   (9)   and secure with nuts (7). (8) Slide  fan  (5)  and  washer  (4)  onto  shaft  (18). Secure with snap ring (3). (9) Install fan cover (2) using nuts (1). f. Replacement. (1) Install   fan   motor   (64,   figure   7-1)   on   motor mount    (65).        Attach    with    bolts    (62)    and washers (63). (2) Install pulley (61). (3) Install  belts  (59)  on  sheaves  (60)  and  pulley (61). (4) Install  belt  guard  (58)  with  screws  (55),  nuts (57 and washers (56). (5) Adjust   belt   tension,   with   motor   mount   (65) adjusting  screw,  allowing  1/2  inch  (13  mm) maximum play of each belt. (6) Connect     electrical     leads     on     fan     motor. Remove tags. 7-6.  FAN AND BEARING REPLACEMENT, CODE A. a. Inspection. (1) Inspect fan (79) for bent or deformed blades. (2) Inspect tightness of attaching bolt and washer for each fan blade. (3) Inspect  fan  bearing  (71)  for  visible  signs  of damage, wear or deterioration. b. Removal.  Remove fan and bearing as follows: (1) Turn off all power.  Disconnect electrical leads on fan motor (64). (2) Remove fan motor mount (65) adjusting screw and  slide  mount  with  motor  to  release  belt tension. (3) Remove  belt  guard  (58)  by  removing  screws (55), nuts (57), and washers (56). (4) Remove belt guards (58). (5) Slide  fan  sheave  (60)  off  bearing  shaft  (71). Remove key from shaft. (6) Remove bolts (72), washers (73 and 74), and nuts (75) and remove fan guard (76). (7) Remove   bolts   (77)   and   washers   (78)   and remove fan blades from fan (79). (8) Remove bolts (66), washers 7-5