TM 5-6115-593-12 TO 35C2-3-463-1 Table 2-2.   Generator Control Panel, Controls and Instruments-Continued FIGURE, INDEX NO. CONTROL AND INSTRUMENT FUNCTION NORMAL READING/SETTING 2-2,18 CLOCK MIN ADJ switch Adjusts clock minute setting. OFF 2-2,19 POWER FACTOR meter Indicates power factor of generator set load. 0.8 lagging to 1.0 2-2,20 KVAR meter Indicates  KVAR  of  3-phase,  4- wire circuits. Less than 75 percent 2-2,21 PARALLEL   OPERATION-   SINGLE UNIT OPERATION switch In PARALLEL OPERATION position,   activates   all   parallel circuits; in SINGLE UNIT OPERATION position, it deactivates all parallel circuits. As required 2-2,22 PARALLEL lamp Lights indicating that PARALLEL switch is in PARALLEL position. OFF 2-2,23 Panel lamp Illuminates panel. OFF 2-2,24 AC  PWR  CKT  BKR-CLOSE-  OPEN circuit Closes/opens  AC  power  circuit breaker Neutral 2-2,25 AC PWR CKT BRK-CLOSED lamp Indicates AC power circuit breaker is in closed position. —   —   — 2-2,26 24V DC CONTROL CIRCUIT BREAKER switch Controls  application  of  24V  DC to control circuits. ON 2-2,27 SYNC light lamps Indicates synchronization of frequency     for     paralleling     of generator set. OFF 2-2,28 SYNCHROSCOPE meter Indicates synchronization of frequency     for     paralleling     of generator set. Floats 2-2,29 PANEL LT SW ON-OFF switch Switches  panel  lamps  on  and off. —   –— 2-2,30 BATTLE SHORT ON-OFF switch Bypasses generator set protective    circuits    during    an emergency,   except   overspeed and short circuits. OFF 2-2,31 TEL JACK Allows  telephone  connection  to remote control module. —   —   — 2-2,32 BATTLE SHORT lamp Indicates BATTLE SHORT switch is ON. OFF 2-7