Figure 6-9. AC Output Control Assembly (Sheet 2 of 2)

Figure 6-9 Output Control Assembly (Sheet 1 of2)

Figure 6-10. AC Output Control Assembly (Switch, Receptacle and Circuit Breaker)

TM-5-6115-585-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 KW 1 Phase 2 Wire 1 Phase-3 Wire 3 Phase-4 Wire 120 120/240 and 120/208 Volts Manual
Page Navigation
68

TM 5-6115-585-34 NAVFAC P-8-623-34 TO-35C2-3-455-2 TM-05684C/05685B-34 1. Screw (1O) 14. Screws (4) 2. Lockwasher (10) 15. Linear reactor 3. Nut (10) 16. Screw (12) 4. Screw (2) 17. Nut(12) 5. Nut (2) 18. Connector (3) 6. Transformer 19. Screw (4) 7. Transformer 20. Nut (4) 8. Screw(6) 21. Connector 9. Lockwasher (6) 22. Nut (4) 10. Load terminal board 23. Bridge rectifier assembly 11. Screw (4) 24. Output control box 12. Lockwasher (4) 25. Load terminal (4) 13. Access panel Figure 6-9. AC Output Control Assembly (Sheet 2 of 2) (4) Convenience Receptacle (J14) (MEP-003A only) (see figure 6-10). Attach new receptacle (13) to front panel with two screws (18) and nuts ( 19). Attach receptacle cover (16) and gasket (17) to front panel with four screws (14) and nuts ( 15). Attach two tagged leads to receptacle per wiring diagram. figure 1- 1. (5) Linear Reactor (L1) (see figure 6-9). Attach new reactor ( 15) to side panel with four screws ( 14). Connect six tagged leads to reactor per wiring diagram, figure 1-1. (6) Connector Assemblies (see figure 6-9). Attach connectors (18 and 21 ) to output control box with screws ( 16 and 19) and nuts (17 and 20). (7) Reconnection Switch (S6) and Transformers (CT 1 and’ CVT 1 ). Assemble transformers (6 and 7, figure 6-9) with screws (4) and nuts (5). Attach tagged wires to transformers and reconnection switch (1, figure 6-10). Refer to wiring diagram, figure 1-1. Install transformers (6 and 7. figure 6-9) with screws (1). nuts (3), and lockwashers (2). Install reconnection switch (1. figure 6-10) with screw (3). lockwasher (4), screw (5), spacer (6). lockwasher (7), and nut (8). (8) Bridge Rectifier Assembly (see figure 6- 9). Position bridge assembly (23) to ac output control box and attach with nuts (22). Connect electrical leads and remove tags. NOTE If any difficulty is encountered in reconnecting the jumpers to the reconnection switch, refer to figure 6-10.1 and 6-10.2. Change 7 6-19

Privacy Statement
Press Release
Contact