Table 1-2. Repair and Replacement Standards (Cont)

Table 1-2. Repair and Replacement Standards (Cont) - TM-5-6115-584-34_33

Figure 11. Generator set Electrical Schematic diagram

TM-5-6115-584-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
9

TM 5-6115-584-34 NAVFAC P-8-622-34 TO-35C2-3-456-2 TM-0568C-34 Table 1-2. Repair and Replacement Standards (Cont) and Tolerances Component FLYWHEEL: Face runout, total Pilot bore eccentricity FLYWHEEL HOUSING: Attaching face deviation Housing bore eccentricity ROCKER ARM MECHANISM: Tappet adjusting screw torque CYLINDER HEAD: Warpage (longitudinally) Warpage (laterally) Manufacturer Dimensions Minimum 4 ft-lbs Maximum 0.0053 0.0020 0.0113 0.005 10 ft-lbs 0.001 0.001 Maximum Allowable Wear Limit 0.0015 0.0015 (7) Oil Cooler. Refer to Operator and m. Engine Repair and Replacement Standards. Table Organizational Maintenance Manual. 1. Safety Devices. (1) High temperature switch. Refer to Operator and Organizational Maintenance Manual. (2) Low oil pressure switch. Refer to Operator and Organizational Maintenance Manual. (3) Fuel level switch (day tank). Refer to Operator and Organizational Maintenance Manual. 1-2 lists manufacturer’s sizes, tolerances, and maxi- mum allowable wear and clearances. n. Schematic Wiring Diagrams. Figure 1-1 shows the schematic wiring diagram of the power plant. o. Torque Values. (1) Table 1-1 lists specific torque values. (2) All torque values are calculated for oil lubri- cated threads. Increase this value by 10 percent when threads are not lubricated. 1-8

Privacy Statement
Press Release
Contact