Table 1-2. Repair and Replacement Standards -(Cont) Manufacturer’s Maximum dimension  and allowable tolerances  in wear  and inches clearance , Components Minimum Maximum Hydraulic  pump  drive  assembly Bore in drive gear for shaft 1.0015 1.0025 0.0005 Fit - drive gear to shaft 0.0002 0.0017 0.0012 inter- inter- ference ference Adapter  assembly  and  fuel  injection  pump  mounting: Bearing   adapter Outside  diameter  of  bearing 1.0850 1.0855 0.0005 Bore in adapter for bearing 1.083 1.084 0.001 Fit  -  bearing-to-bore  in  adapter 0.001 0.0025 0.0015 inter- inter ference ference Bore in bearing after pressing into adapter 0.875 0.877 0.002 Shaft  diameter 0.8735 0.8740 0.0005 Clearance  -  shaft  -to-bearing 0.001 0.0035 0.0025 Lubricating  oil  pressure  pump  (crankshaft  gear 0.874 0.875 0.001 driven)  bore  in  cover  and  body  for  shafts Shaft   outside   diameter 0.8715 0.8720 0.0005 Clearance - shaft to bore in cover and body 000020 0.0035 0.0015 Bore in drive gear - for shaft 0.8695 0.8705 0.005 Fit - shaft to drive gear 0.0010 0.0025 0.0015 inter- inter  - ference ference End  clearance  (gear) 0.0025 0.0065 0.0015 Outside  diameter  of  pressure  gears 2.5694 2.5714 0.002 Bore in body for pressure gears 2.5754 2.5774 0.002 Radial clearance - gears to pump body 0.0020 0.004 0.002 Drive  for  tachometer,  overspeed  and/or  cranking limit  switch Bore  for  bushing  in  housing 0.7495 0.7505 0.001 Outside  diameter  of  bushing 0.752 0.753 0.001 Fit of bushing in housing 0.0015 0.0035 0.0025 inter- inter- ference ference 1-44