Table   1-2.   Repair   and   Replacement   Standards   -(Cont) Components Main    bearings Separate  type  thrust  flanges Front,  intermediate,  center,  and  rear bearing  wall  thickness  (standard  bearings) Bearing   bore   in   cylinder   block   (without   bearing, cap   in   place,   and   capscrews   tightened   to specified  torque) Connecting   rod   bearings: Bore  of  bearing  (with  caps  crews  tightened  to specified  torque) Diameter   of   crankshaft   connecting   rod   journals Connecting   rod   bearing-to-journal   clearance (with   capscrews   tightened   to   specified   torque) Overall   length   of   connecting   rod   bearings Undersize   bearings   available   for   service Bearing   wall   thickness   (standard   bearing) Connecting   rods: Connecting   rod   length   (center-to-center) Bore  of  connecting  rod  bushing  (finished  bore) Bearing  bore  (wit  bout  bearing,  cap  in  place, and   capscrews   tightened   to   specified   torque) Connecting   rod   bearing-to-crankshaft   journal clearance   (with   capscrews   tightened   to specified  torque) Connecting  rod  width  at  lower  end Side  clearance  -to-crankshaft  journal Manufacturer’s dimensions   and tolerances   in inches Minimum Maximum Available   in   standard   size and  0.005,  0.010.0.015 oversize 0.1549 3.5607 2.7495 2.7470 0.001 1.195 0.002 0.010 0.020 0.040 0.10975 8.498 1.5027 2.9700 0.001 1.555 0.005 0.1554 3.5614 2.7510 2.7485 0.0035 1.205 0.11025 8.502 1 5032 2.9705 0.0035 1.557 0.010 Maximum allowable wear  and clearance 0.0019 - - -- 0.0035 0.002 0.0045 0.010 - - - - 0.00175 ---- 0.001 - - -- 0.0045 0.005 0.005 1-38