TM 5-6115-465-12
TO 35C2-3-446-1
NAVFAC P-8-625-12
TM 06858B/06859D-12
Radiator Hose Replacement
( 3 ) To replace radiator hoses, proceed as
( c ) Close the coolant drain valve.
follows:
(d) Fill the radiator with clean
(a) Remove screws and fan guard (fig-
w a t e r and install the radiator cap; approved
cleaning compounds may be used.
(b) Refer to step (2) (b) above and
drain the radiator.
start the engine.
(c) Loosen clamps and remove defec-
(f) Allow the engine to operate un-
til normal operating temperature is reached.
(d) Clean radiator and engine hose
connection
points.
the engine. Open the coolant drain valve to drain
the water.
(e) Remove clamps from defective
hose and place on replacement.
( h ) Close the coolant drain valve.
CAUTION
(i) Fill the radiator with coolant
as specified in table 2-1 and attach a tag speci-
Do not push hose too far in on water
fying the coolant used.
pump outlet pipe and orient clamp so
t h a t it does not scrape against fan
belt.
engine and allow it to operate until normal oper-
ating temperature is reached.
(f) Push replacement hose onto enaine
a n d radiator-connectors and tighten clamps.
( k ) Check coolant level. Add coolant
as necessary.
( g ) Install fan guard and screws.