T O 35C2-3-442-2
P-8-627-34
TM-07464A-35
TM 5-6115-457-34
Legend to figure 7-1:
Insulator
59. Screw (6)
1. Main rotor and shaft
30.
60. Lock washer (6)
Setscrew
assembly
31.
Spacer
61. End bell and exciter
2. Screw (8)
32.
Exciter rotor assembly
stator assembly
3 . Clip locks 4)
33.
Key
62. Screw (4)
4 . Retainer
34.
63. Lock washer (4)
Hub
5. Shaft coupling (3)
35.
Key
64. Connector
6. Fan
36.
Main rotor subassembly
65. Screw (6)
7. Snap ring
37.
Key
66. Lock washer (6)
8. Bearing
38.
Screw (AR*)
67. Washer (6)
9. Nut (5)
39.
Lock washer (AR*)
68. Exciter stator
10. Lock washer (5)
40.
Balance weight (AR*)
11. Setscrew
assembly
41.
Shaft
69. End bell
12. Rectifier assembly
42.
13. Diode lead (6)
Main stator and frame
70. Nut (4)
43.
assembly
14. Nut (3)
71. Lock washer (4)
15. Lock washer (3)
Nut (2)
72. Washer (4)
44.
Lock washer (2)
16. Bolt (3)
73. c l a m p
45,
17. Nut (2)
Screw (2)
74. c l a m p
46.
Screen
18. Lock washer (2)
75. c lamp
47.
Screw (4)
19. Screw (2)
76. Stud
48.
Lock washer (4)
20. Washer (2)
77. Leads (12)
49.
78. Setscrew (2)
Clip (2)
21. Nut (6)
50.
79. Pin (2)
22. Lock washer (6)
Screen
51.
Screw (4)
23. Diode (6)
80. Main stator assembly
52.
Lock washer (4)
81. Lifting eye bolt (2)
24. Rivet (6)
53.
82. Nut (2)
25. Heatsink (2)
Cover
54.
Screw (4)
26. Rivet (4)
55.
83. Screw (4)
27. Washer (4)
Lock washer (4)
84. Name plate
56.
85. Insulation bushing
28. Plate
Clip (2)
57.
86. Main stator frame
29. Hub
Screen
58.
(AR*) As Required
a. Before disassembly, insure that
b. Attach a suitable cable hook and
shipping block (refer to figure 2-1) is in-
lifting device to generators lifting eye (81).
stalled on main stator and frame assembly
Position generator in a vertical position
(43) and fan (6) is secure to shaft couplings
(5).
tor assembly (61) on wooden blocks. Po-
sition two each twelve inch by twelve inch
WARNING
wooden blocks under generator mounting
Insure that generator is properly
brackets on frame assembly (85) to pre-
blocked to prevent injury to per-
vent generator from tipping over. Remove
sonnel during disassembly.
lifting device.
Change 8
7-5
