T.O. 35C2-3-442-2
P-9-TM-457-35
TM 5-6115-457-34
TM-07464A-35
Section IV. CONVENIENCE RECEPTACLE ASSEMBLY
6-57.
6-62.
GENERAL.
INSPECTION.
The 50/60 hertz convenience recep-
a. Inspect connectors for bent, broken
and missing pins. Refer to table 6-5, and
tacle assembly (A22) contains a 125 volt,
15 ampere duplex receptacle, while the
check wires for continuity, shorts to case
400 hertz type contains a 125 volt, 15 am-
and surrounding pins.
pere receptacle and a 125/250 volt, 30
ampere receptacle. Each receptacle has a
b. Check terminal lugs and soldered
connections for condition and security.
spring- loaded weatherproof cover. Both
types have their receptacles connected in
c. Check circuit breakers and recep-
parallel electrically, and have their recep-
tacles for continuity.
tacles protected by a 15 ampere circuit
breaker.
d. Inspect sheet metal parts for dents,
50/60 HERTZ CONVENIENCE
cracks, and distortion.
6-58.
RECEPTACLE ASSEMBLY.
6-63. REPAIR.
6-59. REMOVAL, To remove the assem-
a. Repair defective wiring in accord-
bly (located below the control cubicle),
disconnect plug P48 from the receptacle
ance with table 6-5.
connector J48 in the rear of the assembly,
then remove the six screws and lockwashers
b. Straighten dented or distorted sheet
metal parts using proper tools.
securing the assembly to the rear housing.
6-60. DISASSEMBLY. Refer to figure
6-64, REASSEMBLY. Refer to figure
6-13 and disassemble the 50/60 hertz con-
6-13 and reassemble 50/60 hertz electronic
venience receptacle assembly in the order
component assembly in the reverse order
of index numbers assigned. Pay particular
of index numbers assigned. Pay particular
attention to the following:
attention to the following:
a. Connect wires in accordance with
a. Remove six screw assemblies (1)
and separate the cover (9) from the housing
(24).
b. Install connector plug (4) with key-
b. Tag and disconnect wires from con-
way up.
nector (4) circuit breaker (20) and the
duplex receptacle (17).
6-65. INSTALLATION. Install the 50/60
hertz convenience receptacle assembly in
6-61. CLEANING. Clean all components
the rear housing and secure in position
with a lint-free cloth moistened with an
with six screws and lockwashers. Connect
plug P48 to connector J48 in the rear of
approved cleaning solvent and dry thor-
oughly.
the assembly.
6-33
