INTRODUCTION
available in Army supply channels are assigned
1.Scope
Maintenance Codes only. Source codes, Recovera-
This manuaI lists repair parts, special tools, test
bility codes, and Maintenance Allowances are not
and support equipment required for the perform-
assigned this category.
ance of organizational and direct support main-
(1) Source code indicates the selection status
tenance of the generator sets.
and source for the listed item. Source codes used
are:
2. General
Code
Explanation
This Repair Parts and Special Tools List is
P
Repair parts which are stocked in or supplied
from the GSA/DSA, or Army supply system
divided into the following sections:
and authorized for use at indicated main-
a. Prescribed Load Allowance (PLA)-Section
tenance categories.
II. A composite listing of repair parts, special
P2
Repair parts which are procured and stocked
tools, test and support equipment having quan-
for insurance purposes because the combat
titative allowance for initial stockage at the
or military essentiality of the end item dic-
organizational level.
tates that a minimum quantity be available
in the supply system.
b. Repair Parts -Section III. A list of repair
M
Repair parts, special tools and test equipment
parts authorized for the performance of mainte-
which are not procured or stocked as such,
nance at the organizational level in figure and
in the supply systm, but are to be manu-
item number seqence.
factured at indicated maintenance levels.
c. Special Tools, Test and Support Equipment-
A
Assemblies which are not procured or stocked
Section IV. (Not applicable).
as such, but are made up of two or more
units. Such component units carry individ-
ual stock numbers and decriptions, are pro-
parts authorized for the performance of mainte-
cured and stocked separately and can be
nance at the direct support level in figure and
assembled to form the required assembly at
item number sequence.
indicated maintenance categories.
Parts and assemblies which are not procured
e. Special Tools, Test and Support Equipment-
X
or stocked because the failure rate is nor-
Section VI. (Not applicable).
mally below that of the applicable end item
f. Federal Stock Number and Reference Num-
or component. The failure of such part or
assembly should result int retirement of the
numbers in ascending numerical sequence,
end item from the supply system.
followed by a list of reference numbers appearing
X1
Repair parts which are not procured or
stocked. The requirement for such items
in all of the listing in alpha-numeric sequence,
will be filled by the next higher assembly or
cross-referenced to the illustration figure number
component.
and item number.
Repair parts, special tools and test equipment
X2
NOTE
which are not stocked and have no fore-
Items not illustrated are cross-referenced to
seen mortality. The indicated maintenance
group number.
category requiring such repair parts will
attempt to obtain them through cannibaliza-
3.Explanantion of Columns
tion or salvage. The item may be requisi-
The following provides an explanation of col-
tioned with exception date, from the end
item manager, for immediate use.
umns in the tabular lists in section II through
G
VI.
Major assemblies that are procured with
PEMA funds for initial issue only as ex-
a. Source, Maintenance, and Recoverability
change assemblies at DSU and GSU level.
Codes (SMR).
These assemblies will not be stocked above
GSandDSlevel or returned to depot sup-
NOTE
ply level.
Common hardware items known to be readily
iii
