LO 5-6115-458-12
LUBRICATION ORDER
LO-07536A-12
(Supersedes LO 5-6115-458-12, 17 November 1986)
20 JANUARY 1988
GENERATOR SET, DIESEL ENGINE DRIVEN, SKID MTD., 200 KW,
3 PHASE, 4 WIRE, 120/208/416 VOLTS
DOD MODEL
CLASS
HERTZ
NSN
MEP009A
UTILITY
50/60
MEP108A
PRECISE
50/60
Approved for public release; distribution is unlimited.
Reference: TM 5 6615-458-12 and C9100-IL
Hard time intervals and the related task-hour times are based
Clean fittings before lubricating. Lubricate points indicated by
on normal operation. The task-hour time specified is the time
dotted arrow shaft on both sides of equipment. Clean parts
you need to do all the services prescribed for a particular
with dry-cleaning SOLVENT (SD), type II or equivalent. Dry
interval.
Change the interval if your lubricants are
before lubricating. Drain crankcase when HOT. Fill and
contaminated or if you are operating the equipment under
check level. The lowest level of maintenance authorized to
adverse operating conditions, including longer-than-usual and
lubricate a point is indicated by one of the following: (C)
operating hours.
The interval may be extended during
Operator/Crew; or (O) Organizational Maintenance.
periods of low activity. If extended, adequate preservation
precautions must be taken.
You can help improve this publication. If you find any
mistakes or if you know of a way to improve the procedures,
On-condition (OC) intervals for oil changes shall be
please let us know.
Your letter or DA Form 2028
determined by the Army Oil Analysis Program (AOAP)
(Recommended Changes to Publications and Blank Forms)
laboratory and shall be applied unless otherwise notified.
should be mailed directly to: Commander, US Army Troop
Support Command, ATTN: AMSTR-MCTS, 4300 Goodfellow
Hard time oil change intervals will be applied in the event
Blvd, St. Louis, MO 63120-1798. A reply will be furnished to
AOAP laboratory support is not available.
you.
LUBRICANT INTERVAL
INTERVAL LUBRICANT
Card 1 of 2
