The time specified is the time required to
erform all services at the particular interval
On-condition or hard time).
*TOTAL TASK-HR
*TOTAL TASK-HR
INTERVAL
TASK-HR
TASK-HR
INTERVAL
50H or 60D
0.1
0.6
8
1000
1.0
0.6
100
-KEY-
EXPECTED TEMPERATURES
ABOVE +32 F
+40 P
-10 F
TO -65-F
INTERVALS
CAPACITY
(ABOVE 0 C)
(+5 C TO
-23 C) (-18 C TO -50'C
OE/HDO
LUBRICATING OIL,
Intervals
(MIL-L-2104D)
Engine
OE/HDO 15-40
OE/HDO 15-40
given are
Engine Crankcase
OEA
in hours of
29 qts (27.5L)
with Filters
OR
OR
normal
OE/HDO 30
OE/HDO 10
Oil Can points
operation
LUBRICATING OIL,
(MIL-H-46167) Engine, Subzero
OHA
HYDRAULIC FLUID
8 qts (7.6L)
OHA
(MIL-H-56068) Hydraulic Tank,
Filters and Lines
NOTES:
A sample of the oil shall
5.
CRANKCASE OIL.
FOR OPERATION OF EQUIPMENT IN PROTRACTED
be sent to an AOAP laboratory for analysis at
COLO
TEMPERATURES BELOW -10F (-23'C). Remove
an interval of 50 hours or 60 days.
Refer to
prescribed in
the
for
key
TB 43-0210 for sampling requirements.
temperatures above -1O'F (-23'C). Clean parts
with
drycleaning SOLVENT (SD), type II or
6.
When AOAP laboratory
support is not avail-
equivalent.
Lubricate
with
able, drain and refill
crankcase oil at 300
specified in the key for temperatures O'F to
hours or 6 months.
-65F.
Copy
of
this
Lubrication
Order
will
remain
OIL CAN POINTS.
Every 100 hours
lubricate
2.
with the equipment at all times; instructions
iinges,
latches,
control
and all
contained herein are mandatory.
exposed adjusting threads with OE-HDO.
Every 300 hours remove
3.
ENGINE OIL FILTER.
filter element, clean housing, install new ele-
By Order of the Secretary of the Army:
ment,
fill
crankcase,
operate
engine
for
minutes, check for leaks, check crankcase oil
Oil filter
CARL E. VUONO
level, and bring to FULL mark.
replacement interval shall aline with on-condi-
General, United States Army
time o i l
change
hard
Chief of Staff
tion
AOAP or
official:
requirements.
See notes 5 and 6.
R. L. DILWORTH
SET DIFFERENCES.
Used
on
precise
4.
Brigadier General. United States Army
sets only.
7he Adjutant General
DISTRIBUTION:
To be distributed in accordance with DA Form
12-25A, Operator and Unit Maintenance require-
ments for Generator Set, Diesel Driven, Tacti-
cal, 120/208V, 240/216V, 50/60HZ, 3 PH, 4 Wire
(100KW: MEP-007A,
MEP-106A; 400KW: MEP-116A).
u.s. GOVERNMENT
LO5 -8115-457-12
