ARMY   TM   9-6115-464-34 AIR  FORCE  TO  35C2-3-445-2 NAVY  NAVFAC  P-8-624-34 CHAPTER 2 GENERAL  MAINTENANCE  INSTRUCTIONS Section I. REPAIR PARTS, SPECIAL TOOLS, AND EQUIPMENT 2-1. TOOLS AND SUPPORT EQUIPMENT. There are no special tools or support equipment required to perform any level of maintenance on generator set Models MEP-004A, MEP-103A, and MEP-113A. Table 2-1 contains a list of recommended tools and support equipment normally required to maintain the generator sets at the (direct and general support) and depot maintenance levels. References or illustrations indicating the need or use of these or similar tools areas listed in the table. 2-2. DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE REPAIR PARTS. Direct support, general support and depot maintenance repair parts are listed and illustrated in the, Unit, (Direct and General Support) and Depot Maintenance Repair Parts and Special Tools List). 2-3. FABRICATED TOOLS AND EQUIPMENT. A breakdown cable is required to troubleshoot the electric governor system of MEP-113A. The breakout cable is used to gain access to the Governor Control Unit’s MS3106R20-29 connector. Appendix B gives fabrication instructions for the breakout cable. Table 2-1. TOOLS AND SUPPORT EQUIPMENT Reference Item FSN or Part No. Figure Para. Use Torch outfit, cutting 3433-00-357-6311 or 3-98 Removing  extensively  damaged and welding (Tool equal housing   components Set  L/W67706) Oscilloscope 6625-00-643-1740  or 3-92 Testing  voltage  regulators equal Hoist, chain, 3 ton 3950-00–292-9879   or 2-12 2-6, 2-7 Removing  and  installing  engine equal and  generator  assemblies Trestle, hoist, port– 3950-00-449-7005  or 2-2,2-3 2-6, 2-7 Removing  and  installing  engine able, 5 ton equal and  generator  assemblies Multimeter,  split 6625-00-892-1497  or 3-95 Testing  resistance  of  generator core equal assembly   windings Multimeter, digital 6625-00-495-3513 3-65 Troubleshooting  electric  governor system (MEP-113A only). Ohmmeter 6625-00-643-1030  or 3-95 Testing  continuity  of  generator equal assembly   components Puller  attachment (component  of 5120-00-711-6753 or 3-95 Removing  generator  bearing puller kit equal 5180-701-8046) Solder outfit, electric 3439-00-853-8760  or 3-95 Soldering electrical leads to equal generator assembly rectifiers Test  stand,  actuator 4940-00-152-2107  or 3-43 Testing  performance  of  hydraulic equal actuator 2-1