• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 5-11. Electric Winterization Kit Wiring Harness, Drawing No. 72-2855
AXLE  ASSEMBLIES.

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
  406    407    408    409    410  411  412    413    414    415    416  
ARMY TM 9-6115-464-34 AIR FORCE TO 35C2-3-445-2 NAVY  NAVFAC  P-8-624-34 Section  Ill.  WHEEL  MOUNTING  KIT 5-14.    GENERAL. The wheel mounting kit provides added mobility for the generator set. It consists of a front and a rear axle assembly. The front axle assembly is equipped with a tow bar, pintle and safety chains. A lock holds the tow bar in the vertical position when not in use. A mechanical parking brake locks the wheels of the rear axle assembly against rotation. It is actuated by a hand lever located at the right rear of the generator set. The wheel mounting kit provides 8 inches of ground clearance for the generator set. 5-15. WHEEL MOUNTING KIT INSTALLATION  AND REMOVAL. a.  Installation WARNING Do not use hoisting equipment with maximum capacity less than 5000 pounds. Do not allow generator set to swing while suspended. Failure to observe this warning could result in servere personal injury or death. WARNING Do not allow any part of the body to get under the generator set. Serious injury or death may result from failure to observe this warning. Failure to observe this warning could result in servere personal injury or death. CAUTION Use a minimum bridle of 5 feet on the hoisting sling to avoid undue side pressure on the lifting frame. Failure to observe this caution could result in equipment damage. (1)  Using suitable hoisting equipment, raise the generator set sufficiently to clear axle assemblies. (2)  Position axle assemblies under generator set. (3)  Lower the generator set until it is just touching axle assemblies. (4)  Install attaching hardware as shown in figure 5-12. (5)  Lower generator set until it is supported on the axle assemblies and remove hoisting equipment. b. Removal. Remove wheel mounting kit in reverse order of installation procedures. 5-16.  WHEELS  AND  TIRES. Refer to the Operator and Unit Maintenance Manual for wheels and tires maintenance instructions and alignment procedures. 5-17.  WHEEL  BEARINGS. Refer to the Operator and Unit Maintenance Manual for wheel bearing maintenance instructions. 5-30







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.