• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 3-120. Special Relay Assembly Wiring Harness, Drawing No. 72-2239 (Sheet 4 of 4)
Test  under  frequency  relay  as  follows

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
  286    287    288    289    290  291  292    293    294    295    296  
ARMY  TM  9-6115-464-34 AIR  FORCE  TO  35C2-3-445-2 NAVY  NAVFAC  P-8-624-34 (1) (2) (3) (4) (5) WARNING Compressed air used for cleaning and drying purposes can create airborne particles that may enter the eyes. Pressure shall not exceed 30 psig and use only the adequate chip guards and chipping goggles. Failure to observe this warning could result in servere personal injury or death. WARNING Solvent, Dry Cleaning P-D-680, Type II is flammable and moderately toxic to skin, eyes and respiratory tract. Eye and skin protection required. Good general ventilation is normally adequate. Failure to observe this warning could result in servere personal injury or death. Clean precise relay assembly with filtered compressed air and a soft bristle brush. If necessary, caked deposits may be removed with a clean, lint–free cloth moistened with solvent P-D-680 Type Il. Dry thoroughly after cleaning with solvent. Visually inspect cover and chassis for cracks, corrosion, warping, defective paint and illegible markings. Inspect wiring harness for damaged wires and connectors for bent or broken connector pins and burned areas indicating shorts. Inspect switch (50/60 Hz only) for cracked casing, burns, corroded terminals and other damage. Inspect relays for cracked casing, corroded terminals, and evidence of shorting or other damage. 3-257 Figure   3-121.   DC   Relay   Assembly   Schematic   Diagram c. Cleaning, Inspection, and Repair.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.