• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 3-119. Special Relay Assembly, Exploded View (Sheet 2 of 2)
Figure 3-120. Special Relay Assembly Wiring Harness, Drawing No. 72-2239 (Sheet 1 of 4)

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
  281    282    283    284    285  286  287    288    289    290    291  
ARMY   TM   9-6115-464-34 AIR   FORCE   35C2-3-445-2 NAVY  NAVFAC  P-8-624-34 (13) Install screw & captive washer assembly (10), and nut (9). (14) Install potentiometer (8), tooth Iockwasher (7), nut (6) and locking nut (5). (15) Position chassis (46) to install cover (4), and screw & captive washer assembly (3) e.  Installation. (1) Position special relay assembly to install Iockwashers (2, figure 3-119) and screws (l). (2)  Connect  electrical  connectors  to  special  relay  assembly. 3-91. PRECISE RELAY ASSEMBLY. WARNING Do not attempt to perform maintenance on the precise relay assembly while the generator is operating. Severe electrical shock may result from failure to observe this warning. a. Removal. (1)  Disconnect  electrical  connectors  to  precise  relay  assembly. (2) Remove screws (1, figure 3-123) and Iockwashers (2) to remove precise relay assembly from generator set. NOTE Disassemble only as required to clean, inspect, test, or replace parts. b. Disassembly. (1) (2) (3) (4) (5) (6) (7) (8) (9) (10) Remove screw & captive washer assembly (3, figure 3–1 23) and cover (4). Remove locknuts (5), nut (6), tooth lockwasher (7) and rheostat (8). Remove nut (9), tooth Iockwasher (10), positioning washer (11), and switch (12). Remove nut & captive washer assembly (13), flat washer (14), nut & captive washer assembly (15), and  screw  (16). Remove nut (17), screw & captive washer assembly (18) and wiring harness (19). Remove screw and captive washer assembly (20) and under voltage relay (21). Remove nut (22), screw & captive washer assembly (23) and electronic components assembly (24). Remove nut & captive washer assembly (25), screw (26), terminal board assembly (27) and terminal jumper (28). Remove screw & captive washer assembly (29) and under frequency relay (30). Remove screw & captive washer assembly (31), permissive paralleling relay (32) and chassis (33). NOTE Switch and attaching hardware (items 21 through 24) are found only on the 50/60 Hz precise  relay  assembly. 3-252







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.