TM 9-6115-660-13&P4-4.3 DeprocessingUnpackedEquipment.Refer to DA Form 2258, Depreservation Guide for Vehicles and Equipment, packed with the powerplant/power unit. The depreservation guide explains what was done to the equipment prior to packaging.It also explains what has to be done before placing the equipment in operation. Perform alldepreservation actions required by the depreservation guide.4-5 INSTALLATION INSTRUCTIONS.4-5.1 Tools,TestEquipment,andMaterialsRequiredforInstallation. A general mechanic’s toolkit is required for installation of the power plant/power unit.4-5.2 AssemblyofEquipment.4-5.2.1 AssemblyofPowerPlants.Refer to figure 4-1 and assemble the AN/MJQ-37 and AN/MJQ-38Power Plants as follows:a.b.c.d.e.f.g.h.i.For front generator set, remove stuffing tube locknut (1) from stuffing tube body (7). Slidelocknut (1) off power cable leads and ground cable (3).Loosen compression nut (4). Pull in required length of cable to allow installation of leads onterminal board.Insert power cable leads (ends without terminal lugs) (3) throughSlide stuffing tube locknut (1) over power cable leads.Position stuffing tube body (7) against generator output plate (2).tube locknut (1).Connect power cable leads and ground cable as follows:(1) Connect lead marked L1 to generator set load terminal L1.(2) Connect lead marked L2 to generator set load terminal L2.(3) Connect lead marked L3 to generator set load terminal L3.(4) Connect lead marked L0 to generator set load terminal L0.(5) Connect lead marked GND to generator set GND terminal.generator output plate (2).Install and tighten stuffingPosition cable inside two clamps (10) and secure clamps (10) to trailer using two screws (8), flatwashers (9), and nuts (11).Repeat steps a. through f. for rear generator set.Remove wing nut (12), two flat washers (13), hex nut (14), and flat washer (15).Position ground cable (16) over ground stud (17).4-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
