ARMY TM 9-6115-464-34
AIR FORCE TO 35C2-3-445-2
NAVY NAVFAC P-8-624-34
(28) Attach lifting sling to roof panel assembly, and position on generator set. Ensure alignment pins are
in holes. It may be necessary to use C-clamps to pull the side panels into position using the lifting
clevis as an anchor for the C-clamp. Remove plastic plugs from rotolock holes. Align male and
female rotolocks and, using hex tool, turn rotolocks to secure the roof panel assembly. Remove the
lifting sling. (Refer to figure 5-37.) Install plastic plugs. Install two socket head capscrews to secure
roof panel assembly.
(29) Slide sealing angle into position, and tighten capscrews.
(30) Tighten capscrews securing mounting members.
(31) Attach lifting sling to inlet turn assembly, and position on roof assembly. Remove the lifting sling.
Remove plastic plugs from rotolock holes. Align male and female rotolocks and, using hex tool, turn
rotolocks to secure the inlet turn assembly. (Refer to figure 5-37.) Install plastic plugs.
(32) Attach lifting sling to discharge turn assembly, and position on roof assembly. Remove the lifting
sling. Remove plastic plugs from rotolock holes. Align male and female rotolocks and, using hex tool,
turn rotolocks to secure the discharge turn assembly. (Refer to figure 5-37.) Install plastic plugs.
NOTE
Keepers, washers, and capscrews must be moved to end panels to secure side panel skirts.
(33) Position upper side panel skirt on side panels and install screws, keepers, washers, and capscrews.
(34) Install side panel skirts on slip-joint hinge and secure with keepers.
(35) Lower side panel skirts.
(36) Ensure inlet door, discharge door, control panel access door, and access doors are closed.
(37) Reconnect battery cables.
NOTE
When bottom panel tray assembly is installed, generator set will require one inch
clearance. Stones, debris, or other material may damage bottom tray assembly.
Generator set may not be skidded with bottom panel tray installed.
c. Remove acoustic suppression kit from generator set by reversing installation procedures.
d. If generator set is to be trailer mounted, the following must be performed.
(1) Raise side panel skirts, and install ground wire. Install anti-rotation clips and fiber washers on
capscrews, and install capscrews. Lower side panel skirts.
(2) Glue isolators on skid base or surface of trailer. (Refer to figure 5-34.)
(3) Lower generator set onto trailer. Attach ground wire to trailer.
(4) Install washers and nuts on capscrews to secure generator set.
NOTE
Do not overtighten nuts. Tighten to 5 ft-lb torque (6.80 Nm). Install jam nuts.
(5) Remove hex nuts, capscrews, and locking pins from trailer platform.
(6) Position trailer brackets, and install capscrews, hex nuts, and locking pins on trailer brackets.
5-74
