TM5-6115-634-14&P
NAVFAC P-8-647-14&P
TO-35C2-3-445-14
CHAPTER 4
UNIT MAINTENANCE INSTRUCTIONS
CHAPTER INDEX
Subject Index
Repair Parts, Special Tools, Test, Measurement, and
Diagnostic Equipment (TMDE) and Support Equipment
Preventive Maintenance Checks and Services (PMCS)
Troubleshooting
Maintenance Procedures
Page
4-1
4-1
4-5
4-7
4-1. Scope
Unit maintenance for the PU 794/G is
described in Sections I through IV. For
trailer maintenance instructions, refer
to TM9-2330-205-14&P, and for the genera-
tor set, refer to TM5-6115-464-12.
Section I.
REPAIR PARTS AND SPECIAL TOOLS, TEST, MEASUREMENT,
AND DIAGNOSTIC EQUIPMENT (TMDE) AND SUPPORT EQUIPMENT
4-2. Special Tools and Equipment
Special tools for the generator
set are listed in TM5-6116-464-24P.
Tools required to perform unit mainte-
nance are listed in Appendix C of
TM5-6115-464-12.
b.
Special tools for the trailer are
listed in TM9-2330-205-14&P.
c.
For authorized common tools and
equipment refer to the Modified Table of
Organization and Equipment (MTOE) applic-
able to your unit.
b.
Trailer repair parts are listed
and illustrated in TM9-2330-205-14&P.
c.
Repair parts are listed and illu-
strated in Appendix F (RPSTL) covering
unit maintenance of the PU 794/G.
4-4.
Fabricated Tools and Equipment
There is no requirement to fabricate
tools for unit maintenance of the
PU 794/G.
Refer to Appendix G of this
manual for the listing of tools and
equipment required.
4-3.
Repair Parts
Generator set repair parts are
listed and illustrated in TM5-6115-464-24P.
Section II.
PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
4-5. General PMCS
Deficiencies discovered during operation
of the unit shall be noted for future
To insure that the PU 794/G is ready for
correction, to be made as soon as opera-
operation at all times, it must be in-
tion has ceased.
Stop operation immedi-
spected systematically so that defects
ately if a deficiency is noted during
may be discovered and corrected before
operation which would damage the equip-
they result in serious damage or failure.
ment.
All deficiencies and shortcomings
4-1
