TM5-6115-634-14&P NAVFAC  P-8-647-14&P T0-35C2-3-445-14 TM-6115-14&P/1 APPENDIX  C COMPONENTS OF END ITEM AND BASIC ISSUE ITEMS LIST Section  I. INTRODUCTION C-1.  Scope This appendix lists components of end items and basic issue items necessary to inventory items that are required for safe and efficient operation. C-2. General (1)   Column (1).       Illustration The components of end item and basic issue items lists are divided into the following sections: a. Section  II. Components  of  End Item. This listing is for informational purposes only, and is not the authoriza- tion to requisition replacements. These items are part of the end item, but are removed and separately packaged for transportation or shipment. As part of the end item, these items must be with the end item whenever it is issued or transferred  between  property  accounts. Illustrations are furnished to assist you in identifying the items. b. Section  III. Basic Issue Items. These are the minimum essential items required to place the PU 794/G in opera- tion, to operate it, and to perform emergency repairs. Although shipped separately packaged, BII must be with the PU 794/G during operation and when- ever it is transferred between property accounts. The  illustrations  will  assist you with hard-to-identify items. This manual is your authority to request/ requisition  replacement  611,  based  on Table  of  Organization  and  Equipment/ Modified Table of Organization and Equip- ment (TOE/MTOE) authorization of the end item. The following provides an explanation of columns found in the tabular listings: Number (Illus. Number). This column indicates the number of the illustration in which the item is shown. (2) Column (2). National Stock Number. Indicates the national stock number assigned to the item and will be used for requisitioning purposes. (3) Column (3).  Description. Indicates the national item name, and if required, a minimum description to iden- tify and locate the item. The last line for each item indicates the federal supply code for manufacturer (FSCM) followed by the part number. If item needed differs for different models of this equipment, the model is shown under the ‘USABLE ON’ heading in this column. (4) Column (4). Unit of Measure (U/M) . Indicates the measure used in performing  the  actual  operational/main- tenance function. This measure is expressed  by  a  two-character  alphabeti- cal abbreviation (e.g., ea, in, pr). (5) Column (5). Quantity  Required (Qty Req ). Indicates the quantity of the item authorized to be used with/on the equipment. Not applicable. Section II. COMPONENTS OF END ITEM C-1