Figure 4-10. Battery Cable Fabrication

Figure 4-9. Batteries and Related Items, Exploded View

Section IX. MAINTENANCE OF MUFFLER AND EXHAUST

TM-5-6115-593-12 Power Plant Utility (MUST) Gas Turbine Engine Driven (AMERTECH Corp Model APP-1) Manual
Page Navigation
128

TM 5-6115-593-12 TO 35C2-3-463-1 a. Cut two pieces of sleeving one black and one red 2 inches (5 cm) long, and place them over wire ends. b. Attach terminal lug on end of wire that was previously stripped 0. 62 inch (15. 7 mm). Orient the lug as shown, then crimp the terminal securely. c. Attach battery terminal lug on other end of wire. Orient the lug as shown, then crimp the terminal securely. d. Push sleeving up to terminals and apply heat of 400°F (204°C) for 3 to 5 seconds to obtain proper shrinkage. 4-16. BATTERIES WARNING Do not smoke or use an open flame in the vicinity when servicing batteries. Batteries generate a highly explosive hydrogen gas during charging. Electrolyte is sulfuric acid diluted with water and can cause severe acid burns when spilled on skin or clothing. Use extreme care in handling while servicing batteries. When servicing batteries reference TM9-6140-200-14. Figure 4-10. Battery Cable Fabrication 4-36

Privacy Statement
Press Release
Contact