P-8-627-34
T O 35C2-3-442-2
TM-07464A-35
TM 5-6115-457-34
Legend to figure 8-7:
Yoke assembly
Screw (6)
1.
30.
Pinion housing
Washer
2.
31.
Bearing
Screw (7)
3.
32.
Plug (6)
4.
Lock (7)
33.
Packing
Intermediate housing
5.
34.
Thrust washer
Seal
6.
35.
P lug
Bearing
7.
36.
Gasket
Seal
8.
37.
Thrust washer
Nut
9.
38,
10.
Screw
Thrust washer (4)
39.
11.
Clip
Armature
40.
Nut
Nut
12.
41.
Lock washer
Washer
13.
42.
14.
Insulating washer
Lead assembly
43.
15.
Cap washer
Nut
44.
Washer
Lock washer
16.
45.
Screw (7)
17,
Connector
46.
18.
Lock (7)
Bolt (4)
47.
Head assembly
19.
Solenoid switch
48.
Pin
20.
Bearing
49.
Deleted
21.
Gasket
50.
Deleted
Bushing
22.
51.
Deleted
Insulating washer
23.
52.
Yoke cover
Frame and field assembly
24.
53.
Deleted
Screw (3)
25.
54.
Washer (3)
Pin
26.
55.
Starter drive
Brush (8)
27.
56.
Deleted
Brush plate (8)
28.
57.
Spring
29.
Deleted
58.
Brushes (56) must lie flat against sandpaper
1. Install armature (40) in frame
on armature (40) commutator to obtain de-
and field assembly (53) until armature (40)
sired brush (56) seat contour.
commutator contacts brushes (56).
4. Install armature (40) head as-
2. Raise brushes (56), until brushes
sembly (48) on frame field assembly (53).
are seated on armature (40) commutator.
5. Carefully rotate armature (40) in
3. Cut a strip of No. 00 sandpaper
a counterclockwise direction three to five
the width of the armature (40) commutator.
revolutions to properly seat all brushes
Install sandpaper on armature (38) commu-
(56).
tator with sand side out by raising brushes
6. Remove head assembly (48). Lift
(56) and slipping sandpaper between arma-
all brushes (56) and inspect seat contour
ture (40) commutator and brushes (56).
8-17
Change 8
