-25 to 0F
0 to 20
20 to 125 F
(-6.6 to 51C)
Lubricating oil (MIL-L-
90001) diesel engine
Change oil every
two weeks if
MIL-G-18709 Grease, generator G1
(Shell Alvania #2) Main bearing
GAA Grease Automotive
(MIL-G-10924) and artillery
Copy of this Lubrication Order will remain with the
1. Check crankcase indicator on right hand side
equipment at all times. Instructions contained here-
of pan. Add oil as required.
in are mandatory.
2. Generator set must be shut down to grease generator
By Order of the Secretaries of the Army, and the Marine
G1 main bearing. Refer to TM 5-6115-604-12. Chapter
3, for procedure.
JOHN A. WICKHAM. JR.
General, United States Army
3. Change lubricating oil when replacing filters. Prime
Official: Chief of Staff
lube system. Refer to TM 5-6115-604-12 Chapter 3 for
procedure. Oil gasket of new filter before installing.
Observe filter for 15 minutes after installation to verify
R. L. DILWORTH
Brigadier General, United States Army
good seal. Remove filter and oil gasket again if leaks
The Adjutant General
4. Clean fittings before lubricating. Lubricate with
GEORGE B. CRIST
Lieutenant General, USMC
Deputy Chief of Staff for Installations and Logistics
You can help improve this lubrication order. If you
find any mistakes or if you know of a way to improve
To be distributed in accordance with DA
procedures, please let us know. Mail your letter
Form 12-25A, Operator and Organizational
or DA Form 2028 (Recommended Changes to
Publications and Blank Forms) direct to: Commander,
US Army Troop Support Command, ATTN: AMSTR-
Skid Mounted, 2400/416V, 2200/3800V, 750KW,
MCTS, 4300 Goodfellow Blvd., St. Louis, MO 61310-
50/60HZ, 3PH, 4 Wire (MEP209A)
1798. A reply will be furnished to you.
Card 2 of 2