LUBRICATION ORDER
L O 5-6115-545-12
LI-00038G-12
(Supersedes LO5-6115-645-12, 24 October 1986)
20 January 1988
Approved for public release. Distribution is unlimited.
SET,
DIESEL
DRIVEN,
60
KW,
120/208-240/416V,
3
PHASE,
4
WIRE,
50-60
HERTZ,
SKID
MOUNTED,
(TACTICAL
UTILITY)
NSN
AND
(TACTICAL
PRECISE)
NSN
AND
SET,
DIESEL
DRIVEN,
60
KW,
120/208-240/416V,
3
PHASE,
4
WIRE,
400
HERTZ,
SKID
MOUNTED,
(TACTICAL
PRECISE)
NSN
Referance: TM5-6115-545-12 and C91OO-IL
task-hour
Hard time intervals and the related
Clean fittings before lubricating.
Lubricate
operation.
The
times are based on normal
points indicated by dotted arrow shaft on both
task-hour time specified is the time you need
sides of equipment. Clean parts with dryclean-
to do all
the services prescribed for a
ing SOLVENT (SD), type II or equivalent.
Dry
Change the interval if
particular interval.
before lubricating.
Drain crankcase when HOT.
your lubricants are contaminated or if you are
The lowest level of
Fill and check level.
operating the equipment under adverse operat-
maintenance authorized to lubricate a point is
longer-than-usual
ing
(c)
including
conditions,
indicated by
one
of
following:
the
The interval may be extended
operating hours.
Operator/Crew; or (0) Organizational Mainte-
If extended,
during periods of low activity.
nance.
must be
adequate
preservation
precautions
taken.
You can help improve this publication.
If y o u
find any mistake or if you know of a way to
On-condition (OC) intervals for oil changes
improve the procedures, please let us know.
shall be determined by the Army Oil Analysis
your letter or DA Form 2028 (Recommended
Program (AOAP) laboratory and shall be applied
Publications
Changes to
and
Blank
Forms)
unless otherwise notified.
should be mailed directly to: Commander, US
Army Troop Support Command, ATTN: AMSTR-MCTS,
Hard time oil change intervals will be applied
4300
Goodfellow
Blvd,
St.
Louis, MO
in the event AOAP laboratory support is not
63120-1798.
A reply will be furnished to you.
available.
INTERVAL
LUBRICANT
LUBRICANT
INTERVAL
q
q
Hydraulic Filter (0)
(See notes 5 & 6)
Hydraulic Sump Sight
Engine Accessory
Gage (C) (check
level) (See note 5)
(Sealed bearings; no
lubrication required)
Hydraulic
Sump Fill
and Drain
Plugs (0)
Oil Filters (0)
(Drain
and fill)
AOAP analysis
(See key
& note 5)
(Disassemble, clean,
and replace elements)
(See notes 3, 7, & 8)
Crankcase Oil Fill
Cap and Level Gage.
(C) (check level)
(See key & note 4)
When EOA
CAUTION:
Starter
oil is used, check
(Sealed bearings; no
level more often.
lubrication required)
Engine Oil Drain (0)
on-condition
Air Cleaner, Dry Type
AOAP analysis
(No lubrication
(Drain and fill)
required)
(See notes 7 & 3)
Main Generator
(Sealed bearings; no
lubrication required)
CARD 1 OF 2
