• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 5-24.  PU-798A and PU-799A Generator Mounting Rail Replacement.
Figure 5-25.  Rear Leveling-Support Jack Replacement; High Mobility Trailer

TM-9-6115-660-13P Power Plant Diesel Engine Driven 1-Ton Trailer Mounted (With Racks) 3Kw 60 Hz AN/MJQ-42 Manual
Page Navigation
  164    165    166    167    168  169  170    171    172    173    174  
TM 9-6115-660-13&P 5-21 HIGH MOBILITY TRAILER REAR LEVELING-SUPPORT JACK MAINTENANCE. This task covers: a. Removal c.   Installation b. Repair INITIAL SETUP Tools Equipment Conditions Tool Kit, General Mechanic’s Reference (item 1, appendix B) Jack Stand (item 2, appendix B) Trailer handbrakes set and front support leg/landing leg lowered; paragraph 2-3.2.1. Materials/Parts Both generator sets shut down; paragraph Pin, Cotter 2-5.3.3 Pin, Spring Fitting, Lubrication (if needed) Grease, GAA (item 2, Appendix E) Rivets (item 11, appendix I) REMOVAL WARNING Before  removing  trailer  leveling-support  jack,  support  rear  of  trailer  with  jack  stands. Failure to observe this WARNING can cause severe personal injury or death. 1. Support rear of trailer with jack stands. 2. Turn leg base (1, figure 5-25) to take weight off leg prop. 3. Remove either one of two cotter pins (2 or 3) from pivot shaft (4) and discard cotter pin. 4. Hold leg base (1) steady and remove pivot shaft (4) with remaining cotter pin in place. 5. Lift leg base (1) slightly to take weight off retaining pin (5) and remove retaining pin.  Move leg base (1) and attached parts out of bracket (7). 6. Remove three rivets (6) and bracket (7) from trailer chassis (8). Change 2  5-45







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.