• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
5-16 DIODES  CR1-CR4  MAINTENANCE.
Figure 5-20.  PU-798A and PU-799A Floor Replacement.

TM-9-6115-660-13P Power Plant Diesel Engine Driven 1-Ton Trailer Mounted (With Racks) 3Kw 60 Hz AN/MJQ-42 Manual
Page Navigation
  156    157    158    159    160  161  162    163    164    165    166  
TM 9-6115-660-13&P INSTALLATION 1. Refer to wiring diagram (figure FO-1) and solder diode leads to terminal studs (14) as applicable. 2. Invert  relay  board  assembly  (4)  and  install  four  flat  washers  (3),  lock  washers  (2),  and  screws  (1).  5-16.1  PU-798A AND PU-799A FLOOR AND FENDER MAINTENANCE. 5-16.1 PU-798A AND PU-799A FLOOR AND FENDER MAINTENANCE. This task covers: a. Removal c. Installation b. Repair INITIAL SETUP Tools Equipment Conditions Tool Kit, General Mechanic’s Reference (item 1, appendix B) Rivet Gun (item 8, appendix B) Generator set shut down; paragraph 2-5.3.3. Materials/Parts Trailer handbrakes set, front support leg/landing lowered, and rear leveling-support Rivets (items 6 and 7, appendix I) jacks lowered; paragraph 2-3.2.1. Accessory box removed; paragraph 4-19. REMOVAL 1. Floors. NOTE PU-798A  and  PU-799A  trailers  have  center  and  side  floors  or  platforms  riveted  to  the trailer.  The side floors are in two sections. 1. Remove rivets (1, figure 5-20) and floor sections (2) from trailer chassis (3). 2. Fenders. a. If necessary, remove the following: (1) Data plate (paragraph 4-22). (2) Fire extinguisher and bracket (paragraph 4-20). (3) Side marker light and reflector (TM 9-2330-392-14&P). b. Remove rivets (1, figure 5-21) and fender (2) from trailer chassis (3). Change 2  5-37







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.